Linux下安装Zookeeper

Zookeeper是一个协调服务，可以用它来作为配置维护、名字服务、分布式部署；

下面，我来分享一下在Linux下安装Zookeeper的整个步骤，让大家少走弯路。

一、Zookeeper下载

[root@localhost 下载]# wget http://mirror.bit.edu.cn/apache/zookeeper/zookeeper-3.3.6/zookeeper-3.3.6.tar.gz
--2016-01-15 23:15:57--  http://mirror.bit.edu.cn/apache/zookeeper/zookeeper-3.3.6/zookeeper-3.3.6.tar.gz
正在解析主机 mirror.bit.edu.cn (mirror.bit.edu.cn)... 114.247.56.117
正在连接 mirror.bit.edu.cn (mirror.bit.edu.cn)|114.247.56.117|:80... 已连接。
已发出 HTTP 请求，正在等待回应... 200 OK
长度：11833706 (11M) [application/octet-stream]
正在保存至: “zookeeper-3.3.6.tar.gz”

100%[======================================================================================================================================================================================>] 11,833,706   171KB/s 用时 68s    

2016-01-15 23:17:07 (170 KB/s) - 已保存 “zookeeper-3.3.6.tar.gz” [11833706/11833706])

二、解压

[root@localhost deploy]# tar -zxvf /home/lk/下载/zookeeper-3.3.6.tar.gz 

解压完之后，会在deploy文件夹下面得到一个zookeeper-3.3.6的文件夹

三、进入到conf目录

[root@localhost deploy]# cd /opt/deploy/zookeeper-3.3.6/conf

四、拷贝zoo_samle.cfg为zoo.cfg

[root@localhost conf]# cp zoo_sample.cfg zoo.cfg

五、编辑zoo.cfg文件

[root@localhost conf]# vi zoo.cfg 

修改为：

# The number of milliseconds of each tick
tickTime=2000
# The number of ticks that the initial
# synchronization phase can take
initLimit=10
# The number of ticks that can pass between
# sending a request and getting an acknowledgement
syncLimit=5
# the directory where the snapshot is stored.
dataDir=/usr/zookeeper
dataLogDir=/usr/zookeeper/log
# the port at which the clients will connect
clientPort=2181
server.1=192.168.32.129:2888:3888

六、设置环境变量

[root@localhost conf]# export ZOOKEEPER_INSTALL=/opt/deploy/zookeeper-3.3.6
[root@localhost conf]# export PATH=$PATH:$ZOOKEEPER_INSTALL/bin

七、启动

[root@localhost bin]# ./zkServer.sh start
JMX enabled by default
Using config: /opt/deploy/zookeeper-3.3.6/bin/../conf/zoo.cfg
Starting zookeeper ... STARTED
[root@localhost bin]# 

八、测试zookeeper

[root@localhost bin]# ./zkCli.sh -server 192.168.32.129:2181

如果是本地连接，那么不需要 -server 192.168.32.129:2181,默认是本地

注意：如果出现拒绝连接，请检查如下：

1、防火墙是否关闭  systemctl stop firewalld

2、需要将192.168.32.129 映射到本地 /etc/hosts文件中，否则无法连接