ZigBee and Wi-Fi Coexistence[转载]

原文

ZigBee and Wi-Fi channels both exist in the 2.4 GHz band, existing in the exact same frequency space. When deploying both Wi-Fi and ZigBee in the same environments, careful planning must be performed to make sure that they don't interfere with each other.
Operating a ZigBee network and a Wi-Fi network on the same frequency will cause them to interfere with each other. Usually, the ZigBee network will take the hit.

ZigBee and Wi-Fi Channels

ZigBee and Wi-Fi channel numbers may seem similar, suggesting that they won't overlap. Unfortunately, this is not the case.

2.4 GHz Wi-Fi Channels

2.4 GHz ZigBee Channels

Wi-Fi's three non-overlapping channels (1, 6, and 11) use the exact same frequencies as ZigBee channels 11-22.
ZigBee channels 23-25 aren't immune either, because they can be caught in Wi-Fi channel 11's sideband lobe (see Sideband Lobes below).
ZigBee channel 26 is usually unaffected by Wi-Fi, but many ZigBee devices do not support it.

Interference

When a Wi-Fi network is on the same channel as a ZigBee network, the Wi-Fi network will usually interfere with the ZigBee network.

Interference

Sideband Interference

An 802.11g/n signature in the spectrum has two components:
The 20 MHz "square" section that contains the data subcarriers
Sideband lobes on each side, which are a normal side effect

Sideband lobes might not carry Wi-Fi data, but they are fully capable of downing out ZigBee transmissions.

3.png

Sideband lobes are usually only visible when you are very close to to the device that is actively transmitting (try doing a speed test or streaming an HD video). This is especially evident when your ZigBee access point and Wi-Fi access point are in very close proximity with each other (like in the same comm closet).

4.png

Channel Planning

When deploying ZigBee and Wi-Fi networks in the same environment, channel planning for peaceful coexistence is key.
Normally, we get three Wi-Fi channels to work with (utilizing 1, 6, and 11), but to make room for ZigBee, we may have give up channel 11.

When we deploy our AP's around the house, we'll want to keep the same-channel access points as far away from each other as possible to avoid co-channel interference.

5.png

Dealing with Neighbors

Most deployments have neighbors, and they typically run their own wireless networks, which have unpredictable channels.
When you deploy your wireless network, use Chanalyzer + Wi-Spy to:
Identify what channels the neighbors are using
Choose the best channels for your Wi-Fi network
Perform throughput testing on your Wi-Fi network to determine what ZigBee channels they will interfere with
Deploy ZigBee networks on channels that don't receive interference from your Wi-Fi, or the neighbors Wi-Fi.

6.png