BGP的消息报文有以下5种报文

    open消息

keepalive消息

update消息

notifacation消息

route-refresh消息


jOpen消息

主要包含的内容:

BGP版本、AS号(可用其判断是EBGP还是IBGP);

Holdtime(表示路由器在收到Keeplive消息等待最长时间,cisco默认为180s,如果双方的holdtime时间不一样,邻居不会down,这点与OSPF不同,在BGP中将会协商,采用最小的holdtime时间作为双方的holdtime时间,一般情况下,该值为keepalive的三台,默认情况下keepalive时间为60s);

BGP标识符(router-id);

可选项optionalpareameter(包含多协议支持的地址簇等);

BGP的消息报文类型_第1张图片


kKeepalive消息

是响应Open消息,用于保持邻居关系,没有携带什么消息及数据,默认情况下,60s发送一次keepalive消息;

BGP的消息报文类型_第2张图片


lnotification消息

对错误的配置进行响应,具有差错检测功能,当检测到错误时,会向对等体发送notification消息,并关闭BGP连接;

BGP的消息报文类型_第3张图片

从中可知,有错误类型、错误代码、错误子代码(错误原因)

*Dec  7 11:35:38.747: %BGP_SESSION-5-ADJCHANGE:neighbor 12.1.1.1 IPv4 Unicast topology base removed from session  BGP Notificationsent


mUpdate消息

用于对等体之间通告路由、已撤消的前辍路由、NLRI(网络可达性消息)、路径属性值;

BGP的消息报文类型_第4张图片

Withdrawn routeslength 表示不可达路由长度

Total pathattribute length 总路径属性长度,如果是0表示没有path attributes字段;


nroute-Refresh消息

要求对等体重新发送路由更新信息,可用clearip bgp * soft in软清让路由器重新发送路由更新信息;

BGP的消息报文类型_第5张图片

Address familyidentifier AFI: 地址族标识

Subsequesnt addressfamily identifierSAFI)子地址族标识


R2#show ip bgp neighbors  //用此命令可查看refresh报文的情况

BGP neighbor is4.4.4.4,  remote AS 100, internal link

  BGP version 4, remote router ID 4.4.4.4

  BGP state = Established, up for 00:11:33

  Last read 00:00:40, last write 00:00:08, holdtime is 180, keepalive interval is 60 seconds

  Neighbor sessions:

    1 active, is not multisession capable(disabled)

  Neighbor capabilities:

    Route refresh: advertised and received(new)

    Four-octets ASN Capability: advertised andreceived

    Address family IPv4 Unicast: advertised andreceived

    Enhanced Refresh Capability: advertised andreceived

    Multisession Capability:

    Stateful switchover support enabled: NO forsession 1

  Message statistics:

    InQ depth is 0

    OutQ depth is 0

                             Sent       Rcvd

    Opens:                  1          1

    Notifications:          0          0

    Updates:                4          1

    Keepalives:            14         14

    Route Refresh:          0          0

    Total:                 19         16

在上面可知,route refresh的报文数为零,执行命令后

R2#clear ip bgp* soft in

R2#show ip bgpneighbors  //再次查看情况

BGP neighbor is4.4.4.4,  remote AS 100, internal link

  BGP version 4, remote router ID 4.4.4.4

  BGP state = Established, up for 00:11:33

  Last read 00:00:40, last write 00:00:08, holdtime is 180, keepalive interval is 60 seconds

  Neighbor sessions:

    1 active, is not multisession capable(disabled)

  Neighbor capabilities:

    Route refresh: advertised and received(new)

    Four-octets ASN Capability: advertised andreceived

    Address family IPv4 Unicast: advertised andreceived

    Enhanced Refresh Capability: advertised andreceived

    Multisession Capability:

    Stateful switchover support enabled: NO forsession 1

  Message statistics:

    InQ depth is 0

    OutQ depth is 0

                             Sent       Rcvd

    Opens:                  1          1

    Notifications:          0          0

    Updates:                5          1

    Keepalives:            24         25

    Route Refresh:          1          0

    Total:                 33         31