How to deploy a vm with lvm enabled

1. Attach a 15GB disk into the vm

1. Check if the data disk has been attached.

1. Verify if the attached disk could be detected by fdisk -l command.

1. Create new physical volume on the attached disk

1. Create a vg in pv /dev/sdc

1. Create a volume in the vg bruce_vg

1. Create a file system on the volume

1. Mount the file system

1. Captured imge

1. Deploy a new VM based on the p_w_picpath

1. One the new vm you will see the lvm file systems, and you could mount it again or another point

1. Two vms