hi3520d无线视网络频传输开发总结

1.播放rtsp流地址,在vlc上打开

rtsp://192.168.1.21/xstrive0 


2. vi  /etc/init.d/rcS

insmod rtutil3070ap.ko                    
insmod rt3070ap.ko                        
insmod rtnet3070ap.ko                    
ifconfig ra0 up                          
ifconfig ra0 192.168.1.21 netmask 255.255.255.0
cd /usr/xstrive/ko && ./load3520D_xstrive -i 8d1 128M nvp1914c
route add default gateway 192.168.1.1                         
cd /usr/xstrive &&./live555MediaServer &                      
udhcpd /etc/udhcpd.conf &


3. vi  /etc/udhcpd.conf
# Sample udhcpd configuration file (/etc/udhcpd.conf)
# Values shown are defaults

# The start and end of the IP lease block
start           192.168.1.20
end             192.168.1.254

# The interface that udhcpd will use
interface       ra0

# The maximim number of leases (includes addresses reserved
# by OFFER's, DECLINE's, and ARP conficts). Will be corrected
# if it's bigger than IP lease block, but it ok to make it
# smaller than lease block.
#max_leases     254

# The time period at which udhcpd will write out a dhcpd.leases
# file. If this is 0, udhcpd will never automatically write a
# lease file. Specified in seconds.
#auto_time      7200

# The amount of time that an IP will be reserved (leased to nobody)
# if a DHCP decline message is received (seconds).
#decline_time   3600                                               
                                                                   
# The amount of time that an IP will be reserved                   
# if an ARP conflct occurs (seconds).                              
#conflict_time  3600                                               
                                                                   
# How long an offered address is reserved (seconds).               
#offer_time     60                                                 
                                                                   
# If client asks for lease below this value, it will be rounded up
# to this value (seconds).                                         
#min_lease      60                                                       
                                                                         
# The location of the leases file                                        
#lease_file     /var/lib/misc/udhcpd.leases                              
                                                                         
# The location of the pid file                                           
#pidfile        /var/run/udhcpd.pid  
# Everytime udhcpd writes a leases file, the below script will be called.
#notify_file                    # default: no script                     
#notify_file    dumpleases      # useful for debugging                   
                                                                         
# The following are bootp specific options, settable by udhcpd.          
#siaddr         192.168.0.22            #default: 0.0.0.0                
#sname          zorak                   #default: none                   
#boot_file      /var/nfs_root           #default: none                   
                                                                         
# The remainer of options are DHCP options and can be specifed with the  
# keyword 'opt' or 'option'. If an option can take multiple items, such  
# as the dns option, they can be listed on the same line, or multiple    
# lines. The only option with a default is 'lease'.                    
# Examples:                                                            
opt     dns     192.168.10.2 192.168.10.10                               
option  subnet  255.255.255.0                                            
opt     router  192.168.1.1                                              
opt     wins    192.168.10.10                                            
option  dns     129.219.13.81   # appened to above DNS servers for a total of 3
option  domain  local                                                          
option  lease   864000          # 10 days of seconds  
# Currently supported options (for more info, see options.c):                  
#opt subnet                                                                    
#opt timezone                                                                  
#opt router                                                                    
#opt timesrv                                                                   
#opt namesrv                                                                   
#opt dns                                                                       
#opt logsrv                                                                    
#opt cookiesrv                                                                 
#opt lprsrv                                                              
#opt bootsize                                                                  
#opt domain                                                                    
#opt swapsrv                                                                   
#opt rootpath                                                                  
#opt ipttl                                                                     
#opt mtu                                                                       
#opt broadcast                                                                 
#opt wins                                                                      
#opt lease                                                                     
#opt ntpsrv   
#opt tftp                                                                      
#opt bootfile                                                                  
                                                                               
# Static leases map                                                            
#static_lease 00:60:08:11:CE:4E 192.168.0.54                                   
#static_lease 00:60:08:11:CE:3E 192.168.0.44 


4. RT2870AP.dat

#The word of "Default" must not be removed
Default                    
CountryRegion=5            
CountryRegionABand=7       
CountryCode=TW             
BssidNum=1                 
SSID=SHANJIWIFI            
WirelessMode=9             
TxRate=0                   
Channel=11                 
BasicRate=15               
BeaconPeriod=100           
DtimPeriod=1               
TxPower=100                
DisableOLBC=0              
BGProtection=0             
TxAntenna=                 
RxAntenna=                 
TxPreamble=0               
RTSThreshold=2347          
FragThreshold=2346         
TxBurst=1                  
PktAggregate=0  
TurboRate=0                
WmmCapable=0               
APSDCapable=0              
DLSCapable=0               
APAifsn=3;7;1;1            
APCwmin=4;4;3;2            
APCwmax=6;10;4;3           
APTxop=0;0;94;47           
APACM=0;0;0;0              
BSSAifsn=3;7;2;2           
BSSCwmin=4;4;3;2           
BSSCwmax=10;10;4;3         
BSSTxop=0;0;94;47          
BSSACM=0;0;0;0             
AckPolicy=0;0;0;0          
NoForwarding=0             
NoForwardingBTNBSSID=0     
HideSSID=0                 
StationKeepAlive=0         
ShortSlot=1                
AutoChannelSelect=0        
IEEE8021X=0  
IEEE80211H=0                              
CSPeriod=10                
WirelessEvent=0            
IdsEnable=0                
AuthFloodThreshold=32      
AssocReqFloodThreshold=32  
ReassocReqFloodThreshold=32
ProbeReqFloodThreshold=32  
DisassocFloodThreshold=32  
DeauthFloodThreshold=32    
EapReqFooldThreshold=32    
PreAuth=0                  
AuthMode=WPA2PSK           
EncrypType=TKIP            
RekeyInterval=0            
RekeyMethod=DISABLE        
PMKCachePeriod=10          
WPAPSK=shanji123           
DefaultKeyID=1             
Key1Type=0                 
Key1Str=                   
Key2Type=0                 
Key2Str=
Key3Type=0                                
Key3Str=                   
Key4Type=0                 
Key4Str=                   
HSCounter=0                
AccessPolicy0=0            
AccessControlList0=        
AccessPolicy1=0            
AccessControlList1=        
AccessPolicy2=0            
AccessControlList2=        
AccessPolicy3=0            
AccessControlList3=        
WdsEnable=0                
WdsEncrypType=NONE         
WdsList=                   
WdsKey=                    
RADIUS_Server=192.168.2.3  
RADIUS_Port=1812           
RADIUS_Key=ralink          
own_ip_addr=192.168.5.234  
EAPifname=br0              
PreAuthifname=br0   
HT_HTC=0                                  
HT_RDG=0                   
HT_EXTCHA=0                
HT_LinkAdapt=0             
HT_OpMode=0                
HT_MpduDensity=5           
HT_BW=1                    
HT_AutoBA=1                
HT_AMSDU=0                 
HT_BAWinSize=64            
HT_GI=1                    
HT_MCS=33                  
MeshId=MESH                
MeshAutoLink=1             
MeshAuthMode=OPEN          
MeshEncrypType=NONE        
MeshWPAKEY=                
MeshDefaultkey=1           
MeshWEPKEY=                
WscManufacturer=           
WscModelName=              
WscDeviceName=             
WscModelNumber=
WscSerialNumber=


5./etc目录

Wireless     group        mtab         ppp          services
fs-version   init.d       passwd       profile      udev
fstab        inittab      passwd-      protocols    udhcpd.conf


你可能感兴趣的:(嵌入式处理器,rt3070,hi3520d)