putty 命令行参数

putty.exe [-ssh | -telnet | -rlogin | -raw] [user@]host
Example: putty -ssh -l vagrant -pw vagrant -P 2222 127.0.0.1

 -V        print version information and exit
 -pgpfp    print PGP key fingerprints and exit
 -v        show verbose messages
 -load sessname  Load settings from saved session
 -ssh -telnet -rlogin -raw            force use of a particular protocol
 -P port   connect to specified port
 -l user   connect with specified username
 -batch    disable all interactive prompts The following options only apply to SSH connections:  -pw passw login with specified password
 -D [listen-IP:]listen-port           Dynamic SOCKS-based port forwarding
 -L [listen-IP:]listen-port:host:port            Forward local port to remote address
 -R [listen-IP:]listen-port:host:port            Forward remote port to local address
 -X -x     enable / disable X11 forwarding
-A -a     enable / disable agent forwarding
 -t -T     enable / disable pty allocation
-1 -2     force use of particular protocol version
-4 -6     force use of IPv4 or IPv6
 -C        enable compression
-i key    private key file for authentication
 -m file   read remote command(s) from file
 -s        remote command is an SSH subsystem (SSH-2 only)
 -N        don't start a shell/command (SSH-2 only)

自动登录后执行默认的命令：
putty [-pw password] [-m file] user@ip_addr

主要在于-m参数，其后面跟着的是当前目录下存在的一个shell脚本，记住了不是在【远程】的计算上，而是在putty程序的相同目录中