DENIED Redis is running in protected mode

连接sentinel报错

在这里插入代码片DENIED Redis is running in protected mode because protected mode is enabled, no bind address was specified, 
    no authentication password is requested to clients. In this mode connections are only accepted from the loopback interface. 
    If you want to connect from external computers to Redis you may adopt one of the following solutions: 
    1) Just disable protected mode sending the command 'CONFIG SET protected-mode no' from the loopback interface by connecting to Redis from the same host the server is running, however MAKE SURE Redis is not publicly accessible from internet if you do so. Use CONFIG REWRITE to make this change permanent. 
    2) Alternatively you can just disable the protected mode by editing the Redis configuration file, and setting the protected mode option to 'no', and then restarting the server. 
    3) If you started the server manually just for testing, restart it with the '--protected-mode no' option. 
    4) Setup a bind address or an authentication password. NOTE: You only need to do one of the above things in order for the server to start accepting connections from the outside.

大部分解答都是说给redis增加密码，注释掉bind以及设置protected mode 为no。
然而我处理后并不可以，如果有和我一样的情况可以最后再尝试一下
给sentinel.conf增加配置protected mode no，因为哨兵也有可能处于保护模式。