DELL S4048 10G 交换机配置静态聚合

工作中在进行网卡测试时，需要测试Bonding，所以需要对交换机进行聚合，由于很少接触交换机，所以在此进行记录。

DELL S4048 10G 交换机配置静态聚合：

下面是将端口17/18进行静态聚合，17/18端口聚合port-channel 1
前提是17/18口和channel 1 没有在别处使用。在此聚合为channel 1，也可以是channel 2 3 4… 等等，只要没有在别处使用，都可以进聚合，也可以将channel 进行删除，下面也有写。

Dell-S4048-ON-Fibre#configure
Dell-S4048-ON-Fibre(conf)#default interface te1/17
Dell-S4048-ON-Fibre(conf)#default interface te1/18
Dell-S4048-ON-Fibre(conf)#interface range te1/17 - 1/18
Dell-S4048-ON-Fibre(conf-if-range-te-1/13-1/16)#no shutdown
Dell-S4048-ON-Fibre(conf-if-range-te-1/13-1/16)#no switchport 
Dell-S4048-ON-Fibre(conf-if-range-te-1/13-1/16)#exit
Dell-S4048-ON-Fibre(conf)#interface port-channel 1
Dell-S4048-ON-Fibre(conf-if-po-1)#channel-member te1/17
Dell-S4048-ON-Fibre(conf-if-po-1)#channel-member te1/18
Dell-S4048-ON-Fibre(conf-if-po-1)#switchport 
Dell-S4048-ON-Fibre(conf-if-po-1)#no shutdown 
Dell-S4048-ON-Fibre(conf-if-po-1)#exit
Dell-S4048-ON-Fibre(conf)#exit 
Dell-S4048-ON-Fibre#write
!

Dell-S4048-ON-Fibre#

删除port-channel1：
Dell-S4048-ON-Fibre(conf)# no interface port-channel 1
查看port-channel：
Dell-S4048-ON-Fibre# show interfaces port-channel 1
查看所有的channel状态：
Dell-S4048-ON-Fibre# show running-config 

---