[HCIE]防火墙双机热备基础（HRP）

实验目标：pc1pint 通pc2,FW1（主墙）上的接口出现故障之后，可以切换到FW2（备墙）上。

配置步骤：

1.配置各接口IP（略）

2.防火墙接口区域规划

FW1:

firewall zone trust
 set priority 85
 add interface GigabitEthernet0/0/0
 add interface GigabitEthernet1/0/1
#
firewall zone untrust
 set priority 5                           
 add interface GigabitEthernet1/0/0

FW2:

firewall zone trust
 set priority 85
 add interface GigabitEthernet0/0/0
 add interface GigabitEthernet1/0/1
#
firewall zone untrust
 set priority 5                           
 add interface GigabitEthernet1/0/0

3.接口配置vrrp

FW1:

interface GigabitEthernet0/0/0
 undo shutdown
 undo ip binding -instance default
 ip address 192.168.0.1 255.255.255.0
 vrrp vrid 1 virtual-ip 192.168.0.254 active
#
interface GigabitEthernet1/0/0
 undo shutdown
 ip address 172.16.0.1 255.255.255.0
 vrrp vrid 2 virtual-ip 172.16.0.254 active

FW2:

interface GigabitEthernet0/0/0
 undo shutdown
 undo ip binding -instance default
 ip address 192.168.0.2 255.255.255.0
 vrrp vrid 1 virtual-ip 192.168.0.254 stanby

#
interface GigabitEthernet1/0/0
 undo shutdown
 ip address 172.16.0.2 255.255.255.0
 vrrp vrid 2 virtual-ip 172.16.0.254 stanby

4.配置HRP

FW1:

hrp enable
hrp interface GigabitEthernet1/0/1 remote 12.1.1.2

FW2:

hrp enable
hrp interface GigabitEthernet1/0/1 remote 12.1.1.1

配置完成之后主墙显示:HRP_M[FW1] ；备墙显示：HRP_S[FW2]

5.配置策略（只需要在HRP_M上配置，且同步到备墙）

HRP_M[FW1]：

security-policy
 rule name 1
  source-zone trust
  destination-zone untrust
  action permit

6.查看vrrp状态

7.手动切换主备
hrp switch active/hrp seitch standby

8.检验pc1ping pc2;关闭FW1 g0/0/0口（略）