H3C 端口命令

Gigabitethernet_l2 interface view commands:
  arp                    Configure ARP for the interface
  broadcast-suppression  Specify the broadcast storm control
  description            Describe the interface
  dhcp-snooping          DHCP Snooping
  display                Display current system information
  dot1x                  Specify 802.1X configuration information
  duplex                 Status of duplex
  enable                 Enable function
  flow-control           Flow control command
  flow-interval          Set interval of interface statistic
  igmp-snooping          Configure IGMP snooping characteristic
  ip                     IP
  lacp                   Configure LACP Protocol
  lldp                   Link Layer Discovery Protocol(802.1ab)
  logfile                Specify log file configuration
  loopback               Specify loopback of current port
  loopback-detection     Detect if loopback exists
  mac-address            Configure MAC address
  mdi                    Specify mdi type
  mirroring-group        Specify mirroring-group
  mirroring-port         Specify mirroring port
  monitor-port           Specify monitor port
  multicast-suppression  Specify the multicast storm control
  ndp                    Neighbor discovery protocol
  ntdp                   Specify NTDP configuration information
  packet-filter          Specify packet filter
  ping                   Ping function
  port                   Configure or modify aggregate parameters on a port
  port-isolate           Specify port-isolate configuration information
  qos                    Command of QoS(Quality of Service)
  quit                   Exit from current command view
  return                 Exit to User View
  rmon                   Specify RMON
  save                   Save current configuration
  shutdown               Shut down this interface
  speed                  Specify speed of current port
  storm-constrain        Port storm-constrain
  stp                    Spanning tree protocol
  system-guard           System guard function
  tracert                Trace route function
  undo                   Cancel current setting
  unicast-suppression    Specify the unicast storm control
  user-bind              Bind user address
  virtual-cable-test     display virtual cable test information
  voice                  Specify voice VLAN
[TSG552-JG11-01-GigabitEthernet1/0/32]mi
[TSG552-JG11-01-GigabitEthernet1/0/32]mirror
[TSG552-JG11-01-GigabitEthernet1/0/32]mirroring-p
[TSG552-JG11-01-GigabitEthernet1/0/32]mirroring-port ?
  both      Monitor the inbound and outbound packets
  inbound   Monitor the inbound packets
  outbound  Monitor the outbound packets
[TSG552-JG11-01-GigabitEthernet1/0/32]mirroring-port

你可能感兴趣的:(职场,h3c,mirror,休闲)