Cisco WLC Configuration
架构图如下（随便画的，有点丑，将就看老早）
下面以CISCO WLC2106为例，简单介绍配置方法。下面粗体为需要配置的地方或注释。
Welcome to the Cisco Wizard Configuration Tool
Use the '-' character to backup //这里需要输入ESC清空配制恢复出厂值，只要输入reconfig就好了
Would you like to terminate autoinstall? [yes]: yes
System Name [Cisco_a8:70:00] (31 characters max): cisco-2106-test
Enter Administrative User Name (24 characters max): admin
Enter Administrative Password (24 characters max): *****
Re-enter Administrative Password : *****
Management Interface IP Address: 192.168.1.1 //管理接口地址
Management Interface Netmask: 255.255.255.0
Management Interface Default Router: 192.168.1.254 //管理接口的默�J路由
Management Interface VLAN Identifier (0 = untagged): 0 //缺省配置
Management Interface Port Num [1 to 8]: 1 //�⒂�port 1
Management Interface DHCP Server IP Address: 192.168.1.1 //DHCP server 地址
AP Manager Interface IP Address: 192.168.1.10 //AP的管理接口地址
AP-Manager is on Management subnet, using same values
AP Manager Interface DHCP Server (192.168.1.1): //缺省直接回�
Virtual Gateway IP Address: 1.1.1.1 //��M�W�P地址，��WEB�J�C�r用到
Mobility/RF Group Name: 2106-test
Enable Symmetric Mobility Tunneling [yes][NO]: no
Network Name (SSID): test
Allow Static IP Addresses [YES][no]: yes
Configure a RADIUS Server now? [YES][no]: no //不配置�J�C
Warning! The default WLAN security policy requires a RADIUS server.
Please see documentation for more details.
Enter Country Code list (enter 'help' for a list of countries) [US]: us //��家�^域�a
Enable 802.11b Network [YES][no]: yes
Enable 802.11a Network [YES][no]: yes
Enable 802.11g Network [YES][no]: yes
Enable Auto-RF [YES][no]: yes
Configure a NTP server now? [YES][no]: no
Configure the system time now? [YES][no]: no
Warning! No AP will come up unless the time is set.
Please see documentation for more details.
Configuration correct? If yes, system will save it and reset. [yes][NO]: yes
Configuration saved!
Resetting system with new configuration...
重启WLC 连接网络，GUI模式配制具体
GUI配制需要配制的有：port；interface；WLAN；RF group等
具体配置时，注意LAP的型号如：AIR-LAP1131AG-C-K9
其中C代表CISCO出中国的，那么国家区域码设置要有china（可以设置多个），不然接入LAP可能认不到。
本文出自 “mr0811” 博客，谢绝转载！