CCIE备考LAB:在2611上配置IPV6地址(一)

使用设备:
RTA: Cisco 2611
SWITCH一台
========================
要求
1. 在RTA的E 0/0介面上设定下列IPv6位址
a. Aggregatable global address - 2001:1:1:1::1/64
b. Site-local address - FEC1:1:1:1::2/64
c. Link-local address - FE80:0:0:0:0123:0456:0789:0ABC
2. 检查设定是否正确
3. 检查multicast solicited addresses是否正确
========================
Step1 �⒍�IPv6的功能
RTA(config)#interface ethernet 0/0
RTA(config-if)#ipv6 enable

Step2 设定 Aggregatable global address - 2001:1:1:1::1/64
RTA(config)#interface ethernet 0/0
RTA(config-if)#ipv6 address 2001:1:1:1::1/64
RTA(config-if)#no shutdown
检查一下
RTA#show ipv6 interface ethernet 0/0

Step3 设定 Site-local address - FEC1:1:1:1::2/64
RTA(config)#interface ethernet 0/0
RTA(config-if)#ipv6 address FEC1:1:1:1::2/64
检查一下
RTA#show ipv6 interface ethernet 0/0

Step4 设定 Link-local address - FE80:0:0:0:0123:0456:0789:0ABC
RTA(config)#interface ethernet 0/0
RTA(config-if)#ipv6 address FE80:0:0:0:0123:0456:0789:0ABC link-local
检查一下
RTA#show ipv6 interface ethernet 0/0

Step5 检查设定及检查multicast solicited addresses是否正确
RTA#show running-config interface ethernet 0/0
RTA#show ipv6 interface ethernet 0/0
========================
参考资料:
[url]http://www.cisco.com/en/US/products/ps6553/products_ios_technology_home.html[/url]

本文出自 “沉沦－给生命另外一个起点” 博客，谢绝转载！