在svn中发布多个工程

以前用svn只是在服务上发布一个工程，今天需求来了，要求部署两个，以前没有发布两个，只有现琢磨了，不过最后还是成功了，看下文：

为了方便首先切换到svn的bin目录下，我的是这个

D:\Program Files\Subversion\bin>

依次在cmd中执行下列命令

mkdir d:\myproject1
svnadmin create d:\myproject1\project1
svnserve -d -r d:\myproject1

在输入完第二条命令时，修改下D:\myproject1\project1\conf下的三个文件的内容(只显示修改过的部分)

authz

[groups]
# harryharry_and_sally = harry,sally
# harryharry_sally_and_joe = harry,sally,&joe
[/]
* = rw
ql = rw

passwd

[users]
# harry = harryssecret
# sally = sallyssecret
ql = ql

svnserve.conf

[general]
### These options control access to the repository for unauthenticated
### and authenticated users.  Valid values are "write", "read",
### and "none".  The sample settings below are the defaults.
anon-access = read
auth-access = write
### The password-db option controls the location of the password
### database file.  Unless you specify a path starting with a /,
### the file's location is relative to the directory containing
### this configuration file.
### If SASL is enabled (see below), this file will NOT be used.
### Uncomment the line below to use the default password file.
password-db = passwd
### The authz-db option controls the location of the authorization
### rules for path-based access control.  Unless you specify a path
### starting with a /, the file's location is relative to the the
### directory containing this file.  If you don't specify an
### authz-db, no path-based access control is done.
### Uncomment the line below to use the default authorization file.
authzauthz-db = authz
### This option specifies the authentication realm of the repository.
### If two repositories have the same authentication realm, they should
### have the same password database, and vice versa.  The default realm
### is repository's uuid.
# realm = My First Repository

修改完三个文件后，再执行

svnserve -d -r d:\myproject1

用同样的方法，在myproject1中建立project2，完成后，打开myeclipse，在svn中新建刚才的两个工程svn url为

svn://localhost/project1

svn://localhost/project2

提示输入用户名和密码后，给每个工程添加一个项目，成功后如图

这样以来，在一个svn中就成功的创建了两个或者多个工程了。