Amap服务枚举工具

Amap服务枚举工具

命令使用:

扫描指定端口内正在运行的应用

amap -bq 192.168.1.6 200-500

amap help

amap v5.4 (c) 2011 by van Hauser  www.thc.org/thc-amap
Syntax: amap [-A|-B|-P|-W] [-1buSRHUdqv] [[-m] -o ] [-D ] [-t/-T sec] [-c cons] [
-C retries] [-p proto] [-i ] [target port [port] ...]Modes:
  -A         Map applications: send triggers and analyse responses (default)
  -B         Just grab banners, do not send triggers
  -P         No banner or application stuff - be a (full connect) port scanner
Options:
  -1         Only send triggers to a port until 1st identification. Speeeeed!
  -6         Use IPv6 instead of IPv4
  -b         Print ascii banner of responses
  -i FILE    Nmap machine readable outputfile to read ports from
  -u         Ports specified on commandline are UDP (default is TCP)
  -R         Do NOT identify RPC service
  -H         Do NOT send application triggers marked as potentially harmful
  -U         Do NOT dump unrecognised responses (better for scripting)
  -d         Dump all responses
  -v         Verbose mode, use twice (or more!) for debug (not recommended :-)
  -q         Do not report closed ports, and do not print them as unidentified
  -o FILE [-m] Write output to file FILE, -m creates machine readable output
  -c CONS    Amount of parallel connections to make (default 32, max 256)
  -C RETRIES Number of reconnects on connect timeouts (see -T) (default 3)
  -T SEC     Connect timeout on connection attempts in seconds (default 5)
  -t SEC     Response wait timeout in seconds (default 5)
  -p PROTO   Only send triggers for this protocol (e.g. ftp)
  TARGET PORT   The target address and port(s) to scan (additional to -i)
amap is a tool to identify application protocols on target ports.
Note: this version was NOT compiled with SSL support!
Usage hint: Options "-bqv" are recommended, add "-1" for fast/rush checks.