An example SmartStep application 智能向导应用的一个例子

应用中的过程被控变量

在一个智能向导应用中，操作变量（MVs）是在测试中被操作的独立变量。其中可能包括流量设定点、温度设定点，压力设定点等。

干扰变量，也称为前馈变量（FFs），是那些显著影响过程，但不能被智能向导引擎操作的独立变量。其中可能包括冷却水供水温度，进料组成，环境空气温度等。

被控变量（CVs）则是控制器（和测试仪）应用监视和控制的因变量。其中可能包括产品流组成，温度，压力，压差，阀位，塔液位等。

 STDEMO -一个智能向导应用例子

上图显示了一个精馏单元例子。该单元有5个MV、2个DV和7个CV，列举如下：

操作变量

干扰变量（前馈）

被控变量

测试组

如下所示，两个测试组被配置于本应用中。

斜坡处理设置

下列斜坡处理组被配置为斜坡变量。

也可以看看

测试组

智能向导应用中的斜坡变量

附原文：

Process control variables in an application

In a SmartStep application,manipulated variables (MVs) are those independent variables that are manipulated for testing. These might include flow set points, temperature setpoints, pressure set points, and so forth.

The disturbance variables,also known as feedforward variables (FFs), are independent variables that significantly affect the process, but cannot be manipulated by the SmartStep engine.These might include the cooling water supply temperature, feed composition,ambient air temperature, and so forth.

STDEMO - an example SmartStep application

The figure above shows an example of a fractionation unit. This unit has five manipulated, two disturbance, and seven controlled variables, as listed below:

Manipulated variables

Disturbance variables(Feedforward)

Controlled variables

Testing groups

Two testing groups are configured for this application, as shown below.

Ramp handle setup

The following ramp handle group is configured for the ramp variable.

See Also

Test groups

Ramp variables in a SmartStep application

                                                              2015.10.13