keil:option of project->target

from:http://www.keil.com/support/man/docs/gsac/gsac_toolopts.htm

Set Options for Target

Home » Create Application » Set Options for Target

Set target parameters in the dialog Options for Target - Target.

 Open the dialog via the toolbar icon or the menu Project - Options for Target.

The following options can be set:

Item	Description
Xtal (MHz)	Specifies the XTAL frequency of the device; XTAL is used to configure the debugger and Flash programmer. XTAL reflects the main oscillator connected externally to the device.
Operating system	Choose the operating system. For example, the RTX Kernel adds the correct RTX library and enables kernel aware debugging.
Code Generation
Use Cross-Module Optimization	Enables the linker feedback file, which allows further code optimizations.
Use MicroLIB	Changes the C run-time library-set to generate smallest application code. MicroLIB is not fully ANSI compatible, but sufficient for most small embedded applications.
Use Link-Time Code Generation	Instructs the compiler to create objects in an intermediate format to perform link-time code optimization.
Big Endian	Defines the method used to access multi-byte data.
Read/Only Memory Areas
ROMx	Specify the Read Only Memory areas, typically located in ROM space.
IROMx	Internal Read Only Memory, typically configured by the startup-code.
Read/Write Memory Areas
RAMx	Specify the ZI and RW areas, typically located in RAM space.
IRAMx	Specify the ZI and RW areas, typically configured through the startup-code.
default	The check box, in front of each entry, enables the area globally for the application. Individual modules may be assigned in the Properties dialog to specific areas.
off-chip/on-chip	Specifies whether this is an internal or external ROM or RAM.
Start	Specifies the starting address of the area in HEX format.
Size	Specifies how large the area is. Also in HEX format.
NoInit	Specifies areas that should be excluded from zero initialization.

 Note

• Read/Only Memory Areas and Read/Write Memory Areas are used to create a linker scatter file. In addition, enable the check box Use Memory Layout from Target Dialog in the dialog Linker.