Setting the privilege level

You set the privilege level to access commands at either the administrative or the advanced level.

Step

  1. Enter the following command:

    priv set [-q] [admin | advanced]


    admin sets the privilege level to administrative.

    advanced sets the privilege level to advanced.

    -q enables quiet mode. It suppresses the warning that normally appears when you set the privilege level to advanced.

    Note: If no argument is given, the default, admin, is applied.


    Example


    Assuming the name of the storage system issys1, the storage system prompt is sys1>, as shown in the following example.


    sys1> priv set advanced




      The following message is displayed, followed by the advanced mode storage system prompt.

  1. Warning: These advanced commands are potentially dangerous; use them only when directed to do so by technical personnel.

    sys1*>