Question：1

TimeFinder/Snap virtual devices will be used as the control devices in an Open Replicator implementation. Which Open Replicator copy operation is supported?

A.     Cold Pull

B.     Cold Push

C.     Hot Push

D.     Hot Pull

Answer:B

 

Question：2

A Symmetrix Management Console user has been asked to configure Replication Monitor. Which replication models can be enabled?

A.     SRDF/S, TimeFinder/Clone, and TimeFinder/Snap

B.     SRDF/A, SRDF/Adaptive Copy Disk, and TimeFinder/Clone

C.     SRDF/A, TimeFinder/Clone, and TimeFinder/Snap

D.     SRDF/A, SRDF/S, and TimeFinder/Snap

Answer:D

 

Question：3

An administrator wants to set port flags on an Initiator Group. The command used does not complete successfully.

What is a potential cause of the problem?

A.     An initiator in the group already has a conflicting setting

B.     All initiators in the group have to be logged into the FA ports

C.     Initiator Group has to be a member of a masking view

D.     Initiator Group is empty

Answer:A

 

Question：4

What is an accurate statement about dynamic Symmetrix tiers?

A.     Required for use with FAST VP but not FAST

B.     May be used with FAST VP and FAST

C.     Mixes technology (FC, SATA, and EFD) but not RAID protection

D.     Involves less management overhead than static tiers

Answer:D

 

Question：5

An SRDF/A session is active with Transmit Idle enabled. The device pairs are in a consistent state. What will happen if there is a temporary loss of all links?

A.     Cycle time will be elongated

B.     RTO will increase

C.     Devices will go into a "Synchronous" mode

D.     Devices will go into a "Partitioned" state

Answer:A

本文来源于ciscodk.com，详情咨询QQ 88319073