eNSP配置静态路由实例

1、静态路由

    静态路由的路由项需要手动添加，而非动态路由，其是固定的，不会改变。

2、静态路由配置实例

    （1）实验拓扑如下图所示：

（2）配置命令

  AR1配置命令：

  system-view      #进入系统界面
  [Huawei]interface GigabitEthernet 0/0/0        #  进入G端口
  [Huawei-GigabitEthernet0/0/0]ip addr 10.1.1.1 24           # 配置G端口的IP地址和子网掩码
  [Huawei-GigabitEthernet0/0/0]quit         #    返回上一界面
  [Huawei]interface GigabitEthernet 0/0/1
  [Huawei-GigabitEthernet0/0/1]ip addr 1.1.1.1 24
  [Huawei-GigabitEthernet0/0/1]quit
  [Huawei]ip route-static 20.1.1.0 30 1.1.1.2    #  配置添加静态路由信息    目标网络，掩码，下一跳
  display ip interface brief     #  查看接口与IP相关的配置和统计信息
  *down: administratively down
  ^down: standby
  (l): loopback
  (s): spoofing
  The number of interface that is UP in Physical is 3
  The number of interface that is DOWN in Physical is 1
  The number of interface that is UP in Protocol is 3
  The number of interface that is DOWN in Protocol is 1

  Interface                         IP Address/Mask      Physical   Protocol  
  GigabitEthernet0/0/0              10.1.1.1/24          up         up        
  GigabitEthernet0/0/1              1.1.1.1/24           up         up        
  GigabitEthernet0/0/2              unassigned           down       down      
  NULL0                             unassigned           up         up(s)    



AR2配置命令:

system-view   
[Huawei]interface GigabitEthernet 0/0/0
[Huawei-GigabitEthernet0/0/0]ip addr 1.1.1.2 24
[Huawei-GigabitEthernet0/0/0]quit
[Huawei]interface GigabitEthernet 0/0/1
[Huawei-GigabitEthernet0/0/1]ip addr 20.1.1.1 30
[Huawei-GigabitEthernet0/0/1]quit

[Huawei]ip route-static 10.1.1.0 30 1.1.1.1

 

 

 

 

 

转载于:https://www.cnblogs.com/cyz123/p/11275977.html