Centos yum 报错：Couldn't open file /mnt/redhat73/repodata/repomd.xml

在使用centos7更新yum时，出现错误：

file:///mnt/redhat73/repodata/repomd.xml: [Errno 14] curl#37 - "Couldn't open file /mnt/redhat73/repodata/repomd.xml"
正在尝试其它镜像。
 One of the configured repositories failed (local),
 and yum doesn't have enough cached data to continue. At this point the only
 safe thing yum can do is fail. There are a few ways to work "fix" this:

     1. Contact the upstream for the repository and get them to fix the problem.

     2. Reconfigure the baseurl/etc. for the repository, to point to a working
        upstream. This is most often useful if you are using a newer
        distribution release than is supported by the repository (and the
        packages for the previous distribution release still work).

     3. Run the command with the repository temporarily disabled
            yum --disablerepo=local ...

     4. Disable the repository permanently, so yum won't use it by default. Yum
        will then just ignore the repository until you permanently enable it
        again or use --enablerepo for temporary usage:

            yum-config-manager --disable local
        or
            subscription-manager repos --disable=local

     5. Configure the failing repository to be skipped, if it is unavailable.
        Note that yum will try to contact the repo. when it runs most commands,
        so will have to try and fail each time (and thus. yum will be be much
        slower). If it is a very temporary problem though, this is often a nice
        compromise:

            yum-config-manager --save --setopt=local.skip_if_unavailable=true

failure: repodata/repomd.xml from local: [Errno 256] No more mirrors to try.
file:///mnt/redhat73/repodata/repomd.xml: [Errno 14] curl#37 - "Couldn't open file /mnt/redhat73/repodata/repomd.xml"

解决：

这是因为使用的是虚拟机，本地源路径有问题，若没有本地源，可修改：

$ sudo vi CentOS-local.repo

enabled=0 //禁用本地源

$ sudo yum clean all

$ sudo yum makecache

问题解决。