【openWrt】安装后进行定制

1. • 修改openWrt管理后台默认端口

 vim /etc/config/uhttpd

修改如下图内容

然后重启uhttpd服务即可生效

etc/init.d/uhttpd restart

2. • 修改openWrt软件包源

可以在openwrt后台改

也可以在/etc/opkg/distfeeds.conf直接改

vim /etc/opkg/distfeeds.conf

配置如下

src/gz handsomemod_core https://downloads.openwrt.org/releases/21.02-SNAPSHOT/targets/armvirt/64/packages
src/gz handsomemod_base https://downloads.openwrt.org/releases/21.02-SNAPSHOT/packages/aarch64_cortex-a53/base
src/gz handsomemod_luci https://downloads.openwrt.org/releases/21.02-SNAPSHOT/packages/aarch64_cortex-a53/luci
src/gz handsomemod_packages https://downloads.openwrt.org/releases/21.02-SNAPSHOT/packages/aarch64_cortex-a53/packages
src/gz handsomemod_routing https://downloads.openwrt.org/releases/21.02-SNAPSHOT/packages/aarch64_cortex-a53/routing
src/gz handsomemod_telephony https://downloads.openwrt.org/releases/21.02-SNAPSHOT/packages/aarch64_cortex-a53/telephony
src/gz openwrt_kiddin9 https://op.supes.top/packages/aarch64_cortex-a53

3. • 配置后台地址ip

在operWrt后台修改，配置LAN接口，如果没有，自行新增

4. • 如果openWrt设备作为客户端接入wifi，但无法通过ip地址访问后台，问题排查

注意

1. openwrt的lan网段不能与wifi设备的网段冲突

2. openwrt的后台地址不能与wifi后台地址冲突

将openwrt设备插入电脑，电脑安装rndis驱动，电脑通过openwrt设备连接网络，访问openwrt后台地址进行设置

修改防火墙配置，保存并应用即可