ARCH新装过程

1.根据这个教程走http://bbs.archlinuxcn.org/viewtopic.php?id=1037
fdisk：https://wiki.archlinux.org/index.php/Fdisk
mount：https://wiki.archlinux.org/index.php/Mount
2.出现网络问题时，需要配置

### Basic DHCP network

This setup will enable a DHCP IP for host and container. In this case, both systems will share the same IP as they share the same interfaces.

/etc/systemd/network/*MyDhcp*.network

[Match]
Name=en*

[Network]
DHCP=ipv4


Then, [enable](https://wiki.archlinux.org/index.php/Enable "Enable") and start `systemd-networkd.service` on your container.

You can of course replace `en*` by the full name of your ethernet device given by the output of the `ip link` command.

*   on host and container:


link:https://wiki.archlinux.org/index.php/Systemd-networkd#Basic_DHCP_network

操作为

vim /etc/systemd/network/MyDhcp.network
systemctl enable --now systemd-networkd.service
systemctl start --now systemd-networkd.service
#dhcp配置结束

最后如果上不了网，考虑是否时dns的问题，在配置中添加即可

https://wiki.archlinux.org/index.php/Network_configuration_(%E7%AE%80%E4%BD%93%E4%B8%AD%E6%96%87)#%E5%8A%A8%E6%80%81_IP_%E5%9C%B0%E5%9D%80
https://wiki.archlinux.org/index.php/Systemd-networkd#Basic_DHCP_network
启动服务https://wiki.archlinux.org/index.php/Systemd#Using_units

3.GRUB引导问题

# pacman -S grub os-prober
# grub-install --target=i386-pc /dev/sdX    # sdX 为目标磁盘
#install grub
#fdisk -l 查存储信息
#mount /dev/sbd3 /mnt/ubuntu
#需要在/etc/grub.d/40_custom 自定义的信息，自行填写，这次遇到的问题时LVM格式的盘符无法自动搜索，找到fedora原先的grub.conf，截取fedora部分写入arch的40_custom 中解决。
# grub-mkconfig -o /boot/grub/grub.cfg

GRUB AND LVM:
https://wiki.archlinux.org/index.php/GRUB/Tips_and_tricks#Install_to_partition_or_partitionless_disk
https://wiki.archlinux.org/index.php/GRUB
https://wiki.archlinux.org/index.php/GRUB#Installation_2
https://wiki.archlinux.org/index.php/GRUB_(%E7%AE%80%E4%BD%93%E4%B8%AD%E6%96%87)
https://wiki.archlinux.org/index.php/LVM_(%E7%AE%80%E4%BD%93%E4%B8%AD%E6%96%87)
LVM激活：
https://www.cnblogs.com/apexchu/p/4245117.html