CCNA:cisco的EIGRP标准配置
Router>en
Router#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#host R1
R1(config)#no ip do lo
R1(config)#line cons 0
R1(config-line)#no exec-t
R1(config-line)#logg sync
R1(config-line)#end
R1#conf t
R1(config)#int s1/1
R1(config-if)#ip add 10.1.1 .1 255.255.255.0
R1(config-if)#no sh
R1(config-if)#int lo 0
R1(config-if)#ip add 1.1.1 .1 255.255.255.0
R1(config-if)#no sh
R1(config-if)#int lo 1
R1(config-if)#ip add 3.3.3 .3 255.255.255.0
R1(config-if)#no sh
R1(config-if)#exi
R1(config)#router ei
R1(config)#router eigrp 100
R1(config-router)#no auto-summary
R1(config-router)#net 1.1.1 .0 0.0.0.255
R1(config-router)#net 3.3.3 .0 0.0.0.255
R1(config-router)#net 10.1.1 .0 0.0.0.255
R1(config-router)#
*Sep 11 05:52:42.099: %DUAL-5-NBRCHANGE: IP-EIGRP(0) 100: Neighbor 10.1.1 .2 (Serial1/1) is up: new adjacency
Router>en
Router#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#host R2
R2(config)#no ip do lo
R2(config-line)#no exec-t
R2(config-line)#logg sync
R2(config-line)#end
R2(config)#int s1/0
R2(config-if)#ip add 10.1.1 .2 255.255.255.0
R2(config-if)#no sh
R2(config-if)#int lo 0
R2(config-if)#ip add 2.2.2 .2 255.255.255.0
R2(config-if)#no sh
R2(config)#router eigrp 100
R2(config-router)#no au
R2(config-router)#no auto-summary
R2(config-router)#net 3.3.3 .0 0.0.0.255
R2(config-router)#net 10.1.1 .0 0.0.0.255
R2(config-router)#
*Sep 11 05:52:38.515: %DUAL-5-NBRCHANGE: IP-EIGRP(0) 100: Neighbor 10.1.1 .1 (Serial1/0) is up:
new adjacency
R2(config-router)#no net 3.3.3 .0 0.0.0.255
R2(config-router)#net 2.2.2 .0 0.0.0.255
R2(config-router)#^Z
查看邻居表：
R2#sh ip eigrp neighbors
IP-EIGRP neighbors for process 100
H Address Interface Hold Uptime SRTT RTO Q Seq
(sec) (ms) Cnt Num
0 10.1.1 .1 Se1/0 14 00:09:50 16 200 0 2
查看路由表：
R2#sh ip route
Codes: C - connected, S - static, R - RIP, M - mobile, B - BGP
D - EIGRP, EX - EIGRP external, O - OSPF , IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
i - IS-IS, su - IS-IS summary, L1 - IS-IS level-1, L2 - IS-IS level-2
ia - IS-IS inter area, * - candidate default, U - per-user static route
o - ODR, P - periodic downloaded static route
Gateway of last resort is not set
1.0.0 .0/24 is subnetted, 1 subnets
D 1.1.1 .0 [90/2297856] vi a 10.1.1 .1, 01:10:53, Serial1/0
2.0.0 .0/24 is subnetted, 1 subnets
C 2.2.2 .0 is directly connected, Loopback0
3.0.0 .0/24 is subnetted, 1 subnets
D 3.3.3 .0 [90/2297856] vi a 10.1.1 .1, 01:10:53, Serial1/0
10.0.0 .0/24 is subnetted, 1 subnets
C 10.1.1 .0 is directly connected, Serial1/