NBU 7.0 无法连接到套接字

（25）无法连接到套接字 

解决方法：

/etc/init.d/xinetd restart

（24）无法连接到套接字

解决方法：

先关闭SElinux

vim /etc/selinux/config

# This file controls the state of SELinux on the system.

# SELINUX= can take one of these three values:

#       enforcing - SELinux security policy is enforced.

#       permissive - SELinux prints warnings instead of enforcing.

#       disabled - SELinux is fully disabled.

SELINUX=disabled // 修改为禁用

# SELINUXTYPE= type of policy in use. Possible values are:

#       targeted - Only targeted network daemons are protected.

#       strict - Full SELinux protection.

SELINUXTYPE=targeted

修改安全上下文：

chcon -t textrel_shlib_t /usr/openv/lib/libnbmangle.so

chcon -t textrel_shlib_t /usr/openv/lib/libvxPBXCommon.so

chcon -t textrel_shlib_t /usr/openv/lib/libvxPBX.so

chcon -t textrel_shlib_t /usr/openv/lib/libvxPBXVxSS.so

chcon -t textrel_shlib_t /usr/openv/lib/libvxVxSSIOP.so

chcon -t textrel_shlib_t /usr/openv/lib/libnbservice.so

init 6

再次启用SElinux

vim /etc/selinux/config

# This file controls the state of SELinux on the system.

# SELINUX= can take one of these three values:

#       enforcing - SELinux security policy is enforced.

#       permissive - SELinux prints warnings instead of enforcing.

#       disabled - SELinux is fully disabled.

SELINUX=enforcing  // 修改为启用

# SELINUXTYPE= type of policy in use. Possible values are:

#       targeted - Only targeted network daemons are protected.

#       strict - Full SELinux protection.

SELINUXTYPE=targeted

init 6