Fortiget 断电后firmware和config文件损坏的修复
1.通过console连接fortiget；
2.重启机器，用命令：
FGT60C # execute reboot
This operation will reboot the system !
Do you want to continue? (y/n)
The system is going down NOW !!
System is rebooting...
FGT60C #
Please stand by while rebooting the system.
Restarting system.
nit SSP ...OK
Read SPI ...OK
FortiGate-60C (18:52-06.18.2010)
Ver:04000010
Serial number: FGT60C3G10011492
CPU(00): 525MHz
Total RAM: 512 MB
NAND init... 128 MB
MAC Init... nplite#0
Press any key to display configuration menu...
...
[G]: Get firmware image from TFTP server.
[F]: Format boot device.
[I]: Configuration and information.
[B]: Boot with backup firmware and set as default.
[Q]: Quit menu and continue to boot with default firmware.
[H]: Display this list of options.
Enter G,F,I,Q,or H:
3.重刷firmware image并恢复出厂配置
a.从fortinet网站上下载out文件
b.启动你的tftp server
c.在上面界面中选G后按提示下一步。就可以完成重刷。
Enter G,F,I,Q,or H:
Please connect TFTP server to Ethernet port 'Any of port 1,2,3,4,5'.
Enter TFTP server address [192.168.1.168]: 192.168.11.36
Enter local address [192.168.1.188]: 192.168.11.1
Enter firmware image file name [image.out]: FGT_60C-v400-build0513-FORTINET.out
MAC:00:09:0f:de:b6:10
Connect to tftp server 192.168.11.36 ...
###############################################
Receiving Image OK.
Save as Default firmware/Backup firmware/Run image without saving:[D/B/R]? D
Programming the boot device now.
................... 41025536 bytes written: OK
reading boot image 1173618 bytes.
Initializing firewall...
System is started.
FGT60CXXXXXXX login: admin
Password:
Welcome !
FGT60CXXXXXXX # execute restore config tftp （恢复原来的配置）
<string> the file name on the tftp server
FGT60CXXXXXXX # execute restore config tftp FGT60C_20121120.conf 192.1
68.1.36
This operation will overwrite the current settings!
Do you want to continue? (y/n)y
Please wait...
Connect to tftp server 192.168.1.36 ...
Get config file from tftp server OK.
File check OK.
重启机器后恢复正常。