catalyst 5505 故障排查(模块)

System Bootstrap, Version 5.1(2)
Copyright (c) 1994-1999 by cisco Systems, Inc.
Presto processor with 32768 Kbytes of main memory
Autoboot executing command: "boot bootflash:cat5000-sup3.5-5-13a.bin"
Loading Network Management Processor image
Uncompressing file: 
#########################################################
###################################
##########################################################
##################################
############################################
System Power On Diagnostics
NVRAM Size ...................512 KB
Testing ID Prom ..............Passed
DPRAM Size ...................16 KB
Testing DPRAM Data 0x55 ......Passed
Testing DPRAM Data 0xaa ......Passed
Testing DPRAM Address ........Passed
Clearing DPRAM ...............Done
System DRAM Memory Size ......32 MB
Testing DRAM Data 0x55 .......Passed
Testing DRAM Data 0xaa .......Passed
Testing DRAM Address .........Passed
Clearing DRAM ................Done
EARLIII ......................Present
Testing EARLIII RAM ..........Passed
Testing EARL Serial Prom .....Passed
Level2 Cache .................Present
Testing Level2 Cache .........Passed
Boot image: bootflash:cat5000-sup3.5-5-13a.bin
Downloading epld sram device please wait ...
Programming successful for Altera 10K50 SRAM EPLD
Running System Diagnostics from this Supervisor (Module 1)
This may take up to 2 minutes....please wait
Minor hardware problem in Module # 1
Use 'show test 1' to see results of tests.

Cisco Systems Console
Enter password:
Console>
2009 Feb 18 00:30:50 %MLS-5-NDEDISABLED:Netflow Data Export disabled
Console>
2009 Feb 18 00:30:50 %SYS-5-MOD_OK:Module 1 is online
Console>
Console> (enable) sh conf
This command shows non-default configurations only.
Use 'show config all' to show both default and non-default configurations.
......
...............

................
................
..
begin
!
# ***** NON-DEFAULT CONFIGURATION *****
!
!
#time: Wed Feb 18 2009, 00:30:56
!
#version 5.5(13a)
!
set password $2$Bi8o$ChqfU8OMam7rctD0tCEgO/
set enablepass $2$r3XI$Rrwo/IEYLZVpoPMxtFXFT1
!
#frame distribution method
set port channel all distribution mac both
!
#snmp
set snmp community read-only      netbar
set snmp community read-write    
set snmp community read-write-all
!
#ip
set interface sc0 1 192.168.88.1/255.255.0.0 192.168.255.255
set ip route 0.0.0.0/0.0.0.0         192.168.0.254 
!
#set boot command
set boot config-register 0x102
set boot system flash bootflash:cat5000-sup3.5-5-13a.bin
!
#mls
set mls disable ip
set mls nde disable
!
# default port status is enable
!
!
--More--2009 Feb 18 00:31:13 %SYS-5-MOD_OK:Module 2 is online
#module 1 : 2-port 1000BaseSX Supervisor
set port disable    1/1-2
--More--2009 Feb 18 00:31:18 %SYS-5-MOD_OK:Module 4 is online
---
Console> (enable) sh flash
-#- ED --type-- --crc--- -seek-- nlen -length- -----date/time------ name
  1 .. ffffffff f28db5fe   4371c   12    13979 Mar 15 2006 15:28:22 myconfig.txt
  2 .. ffffffff eda99c3e  500a48   24  4969129 Jun 16 2006 11:31:15 cat5000-sup3.5-5-13a.bin
  3 .. ffffffff e54af2fc  506d24   12    25178 Aug 30 2007 13:14:41 myswitch.cfg

Console> (enable) sh version
WS-C5505 Software, Version McpSW: 5.5(13a) NmpSW: 5.5(13a)
Copyright (c) 1995-2002 by Cisco Systems
NMP S/W compiled on Feb  1 2002, 19:47:47
MCP S/W compiled on Feb 01 2002, 19:41:58
System Bootstrap Version: 5.1(2)
Hardware Version: 1.0  Model: WS-C5505  Serial #: 066539470
Mod Port Model      Serial #  Versions
--- ---- ---------- --------- ----------------------------------------
1   2    WS-X5530   015563875 Hw : 3.4
                              Fw : 5.1(2)
                              Fw1: 4.4(1)
                              Sw : 5.5(13a)
         WS-F5531   015558139 Hw : 2.0
         WS-U5534   024709159 Hw : 1.2
2   24   WS-X5234   029348441 Hw : 1.1
                              Fw : 4.5(2)
                              Sw : 5.5(13a)
4   24   WS-X5225R  017407516 Hw : 3.3
                              Fw : 4.3(1)
                              Sw : 5.5(13a)
5   24   WS-X5225R  020235258 Hw : 3.3
                              Fw : 4.3(1)
                              Sw : 5.5(13a)
       DRAM                    FLASH                   NVRAM
Module Total   Used    Free    Total   Used    Free    Total Used  Free
------ ------- ------- ------- ------- ------- ------- ----- ----- -----
1       32768K  19644K  13124K   8192K   5660K   2532K  512K  204K  308K
Uptime is 0 day, 0 hour, 5 minutes
Console> (enable) sh module
Mod Slot Ports Module-Type               Model               Sub Status
--- ---- ----- ------------------------- ------------------- --- --------
1   1    2     1000BaseSX Supervisor     WS-X5530            yes ok
2   2    24    10/100BaseTX Ethernet     WS-X5234            no  ok
4   4    24    10/100BaseTX Ethernet     WS-X5225R           no  ok
5   5    24    10/100BaseTX Ethernet     WS-X5225R           no  other
Mod Module-Name         Serial-Num
--- ------------------- --------------------
1                       00015563875
2                       00029348441
4                       00017407516
5                       00020235258
Mod MAC-Address(es)                        Hw     Fw         Sw
--- -------------------------------------- ------ ---------- -----------------
1   00-50-54-16-6c-00 to 00-50-54-16-6f-ff 3.4    5.1(2)     5.5(13a)
2   00-04-c0-33-b7-a8 to 00-04-c0-33-b7-bf 1.1    4.5(2)     5.5(13a)
4   00-30-7b-32-07-78 to 00-30-7b-32-07-8f 3.3    4.3(1)     5.5(13a)
5   00-01-63-52-35-b0 to 00-01-63-52-35-c7 3.3    4.3(1)     5.5(13a)
Mod Sub-Type Sub-Model Sub-Serial Sub-Hw
--- -------- --------- ---------- ------
1   NFFC II  WS-F5531  0015558139 2.0
1   uplink   WS-U5534  0024709159 1.2
Console> (enable) sh port
Port  Name               Status     Vlan       Level  Duplex Speed Type
----- ------------------ ---------- ---------- ------ ------ ----- ------------
 1/1                     disabled   1          normal   full  1000 1000BaseSX
 1/2                     disabled   1          normal   full  1000 1000BaseSX
 2/1                     notconnect 1          normal   auto  auto 10/100BaseTX
 2/2                     notconnect 1          normal   auto  auto 10/100BaseTX
 2/3                     notconnect 1          normal   auto  auto 10/100BaseTX

Console> (enable) set port enable 1/1
Port 1/1 enabled.
Console> (enable) set port enable 1/2
Failed to enable port 1/2.
Port may be faulty.
Console> (enable) sh port
Port  Name               Status     Vlan       Level  Duplex Speed Type
----- ------------------ ---------- ---------- ------ ------ ----- ------------
 1/1                     notconnect 1          normal   full  1000 1000BaseSX
 1/2                     disabled   1          normal   full  1000 1000BaseSX
 2/1                     notconnect 1          normal   auto  auto 10/100BaseTX
 2/2                     notconnect 1          normal   auto  auto 10/100BaseTX
2009 Feb 18 00:38:20 %SYS-3-MOD_FAIL:Module 5 failed to come online
Console> (enable) 2009 Feb 18 00:40:21 %SYS-5-MOD_REMOVE:Module 5 has been removed
2009 Feb 18 00:40:27 %SYS-5-MOD_INSERT:Module 5 has been inserted
Console> (enable) Syndiags failed on Module Number 5
Use 'show test 5' to see results of tests.
2009 Feb 18 00:47:40 %SYS-3-MOD_FAIL:Module 5 failed to come online
2009 Feb 18 00:56:15 %SYS-5-MOD_INSERT:Module 3 has been inserted
2009 Feb 18 00:56:45 %SYS-3-MOD_CFGMISMATCH1:Module 3 configuration mismatch.  Ports
disabled
2009 Feb 18 00:56:45 %SYS-3-MOD_CFGMISMATCH2:*Config:24 port 10/100BaseTX (RJ-45)
2009 Feb 18 00:56:45 %SYS-3-MOD_CFGMISMATCH3:*Actual:10/100BaseTX Ethernet
2009 Feb 18 00:56:45 %SYS-3-MOD_CFGMISMATCH4:Insert config type module or do a 'clear config
3'
2009 Feb 18 00:56:48 %SYS-5-MOD_OK:Module 3 is online
-----------
onsole> (enable) sh module
Mod Slot Ports Module-Type               Model               Sub Status
--- ---- ----- ------------------------- ------------------- --- --------
1   1    2     1000BaseSX Supervisor     WS-X5530            yes ok
2   2    24    10/100BaseTX Ethernet     WS-X5234            no  ok
3   3    24    10/100BaseTX Ethernet     WS-X5225R           no  ok
Module 3 mismatch of config and actual type. Ports disabled
Config: 24 port 10/100BaseTX (RJ-45) , Actual: 10/100BaseTX Ethernet
Insert config module type or do a 'clear config 3'
4   4    24    10/100BaseTX Ethernet     WS-X5225R           no  ok
Mod Module-Name         Serial-Num
--- ------------------- --------------------
1                       00015563875
2                       00029348441
3                       00020235258
4                       00017407516
Mod MAC-Address(es)                        Hw     Fw         Sw
--- -------------------------------------- ------ ---------- -----------------
1   00-50-54-16-6c-00 to 00-50-54-16-6f-ff 3.4    5.1(2)     5.5(13a)
2   00-04-c0-33-b7-a8 to 00-04-c0-33-b7-bf 1.1    4.5(2)     5.5(13a)
3   00-01-63-52-35-b0 to 00-01-63-52-35-c7 3.3    4.3(1)     5.5(13a)
4   00-30-7b-32-07-78 to 00-30-7b-32-07-8f 3.3    4.3(1)     5.5(13a)
Console> (enable) sh config
------
#module 3 : 24-port 10/100BaseTX Ethernet
set port disable    3/1-24
-------
-------
Console> (enable) set port enable 3/1-24
Port(s) 3/1-24 enabled.
 
Console> (enable) sh module
Mod Slot Ports Module-Type               Model               Sub Status
--- ---- ----- ------------------------- ------------------- --- --------
1   1    2     1000BaseSX Supervisor     WS-X5530            yes ok
2   2    24    10/100BaseTX Ethernet     WS-X5234            no  ok
3   3    24    10/100BaseTX Ethernet     WS-X5225R           no  ok
4   4    24    10/100BaseTX Ethernet     WS-X5225R           no  ok

你可能感兴趣的:(职场,故障,休闲,catalyst,5505)