光纤交换机Fabriclog 字段意义
fabricLog
Displays (all users) or manipulates (admin) the fabric log.
Synopsis
fabriclog -s | --show [dport]
fabriclog -c | --clear [dport]
fabriclog -d | --disable
fabriclog -e | --enable
fabriclog -rsize | --resizesize
fabriclog -h | --help
Description
Use this command to display, clear, disable, enable, or resize the fabric log. When used with the --show option, this command displays the following information:
Time Stamp
Time of the event in the following format HH:MM:SS:MS.
Input and *Action
Fabric log message. An asterisk (*) in the message indicates an action. The link reset information is indicated by LR_IN and LR_OUT. LR_IN indicates a link reset on the remote switch, whereas LR_OUT indicates a link reset on the local switch.
S
Current switch state. Valid switch states include the following:
FO
Build Fabric (BF) received.
F1
Reconfigure Fabric (RCF) is not supported.
F2
Exchange Fabric Parameters (EFP) is waiting for last Accept Frame (ACC) from flood.
F3
Flood EFPs.
D0
The switch is the principal switch.
D1
The principal switch is sending Domain ID Assigned (DIA).
D2
The principal switch is waiting for Request Domain ID (RDI).
D3
The principle switch is processing the RDI.
A0
The switch is not the principal switch.
A1
The non-principal switch is sending a DIA.
A2
The non-principal switch is waiting for an RDI.
A3
The non-Principal switch is processing an RDI.
S0
The switch is in offline state.
P
Port state.Port states include the following:
PO
The port is offline.
P1
The port is online.
P2
Exchange Link Parameters (ELP) Accept Frame (ACC) received.
P3
Link reset occurred on master or E_Port.
I0
Trunk Initiator: Exchange Mark Timestamp (EMT) sent.
I1
Trunk Initiator: Exchange Trunking Parameters (ETP) Accept Frame (ACC) received.
I2
Trunk Initiator: ETP sent.
I3
Trunk Initiator: Link reset occurred.
I4
Trunk Initiator: Link reset done on slave.
T0
Trunk Target: EMT received.
T1
Trunk Target: ETP received.
T2
Trunk Target: Link reset.
T3
Trunk Target: Link reset done on slave.
LD
Dynamic long distance ECP sent or received.
ESC
Exchange Switch Capabilities (ESC) state between P2 and P3.
Sn
Next switch state. Refer to switch states for valid states.
Pn
Next port state. Refer to port states for valid states.
Port
Port number, if applicable, or NA
Xid
OXID (Exchange ID) Port number, if applicable, or NA