思科、华为、H3C主要命令对照表（三）路由部分

思科	华为	H3C	描述
路由部份：
ip route 0.0.0.0 0.0.0.0	ip route-static 0.0.0.0 0.0.0.0	ip route-static 0.0.0.0 0.0.0.0	配置默认路由
ip route 目标网段+掩码 下一跳	ip route-static 目标网段+掩码 下一跳	ip route-static 目标网段+掩码 下一跳	配置静态路由
show ip route	display ip routing-table	display ip routing-table	查看路由表
router rip /network 网段	rip /network 网段	rip /network 网段	启用rip、并宣告网段
router ospf	ospf enable	ospf enable	启用ospf
network ip 反码 area <area-id>	ospf enable area <area-id>	ospf enable area <area-id>	配置OSPF区域
no auto-summary	rip split-horizon	rip split-horizon	配置RIP V2水平分割
show ip protocol	display ip protocol	display ip protocol	查看路由协议
access-list 1-99 permit/deny IP	rule normal permit source IP	rule normal permit source IP	标准访问控制列表
access-list 100-199 permit/deny protocol source IP+ 反码 destination IP+反码 operator operan	rule {normal|special}{permit|deny}{tcp|udp}source {<ip wild>|any}destination <ip wild>|any}[operate]	rule {normal|special}{permit|deny}{tcp|udp}source {<ip wild>|any}destination <ip wild>|any}[operate]	扩展访问控制列表
standby group-number ip virtual-ip	vrrp vrid number virtual-ip	vrrp vrid number virtual-ip	配置HSRP组
standby group-number priority	vrrp vrid number priority	vrrp vrid number priority	配置HSRP优先级
standby group-number preempt	vrrp vrid number preempt-mode	vrrp vrid number preempt-mode	配置HSRP占先权
standby group-number track	无	无	配置端口跟踪
ip nat inside source static	nat server global <ip> [port] inside <ip> port [protocol]	nat server global <ip> [port] inside <ip> port [protocol]	配置静态地址转换