u-boot-2011.06的移植（一）

直接以smdk6400作为模版进行修改

1、到board目录下

复制smdk6400文件为smdk6410

改smdk6400.c为smdk6410.c

改smdk6400_nand_spl.c为smdk6410_nand_spl.c

并修改此目录下的makefile文件把COBJS-y := smdk6400.o改为COBJS-y := smdk6410.o

2、到arch目录下

把arch\arm\include\asm\arch-s3c64xx目录中的复制s3c6400.h为s3c6410.h

3、到include目录下

把include\configs目录下的smdk6400.h复制为smdk6410.h

4、到nand_spl目录下

把nand_spl\board\samsung目录下的smdk6400文件复制为smdk6410

并进入文件内部修改makefile文件，把其中的smdk6400全部改为smdk6410

5、顶层目录下

修改makefile文件，添加对smdk6410的支持

#########################################################################
## ARM1176 Systems
#########################################################################
smdk6400_noUSB_config \
smdk6400_config : unconfig
@mkdir -p $(obj)include $(obj)board/samsung/smdk6400
@mkdir -p $(obj)nand_spl/board/samsung/smdk6400
@echo "#define CONFIG_NAND_U_BOOT" > $(obj)include/config.h
@echo "CONFIG_NAND_U_BOOT = y" >> $(obj)include/config.mk
@if [ -z "$(findstring smdk6400_noUSB_config,$@)" ]; then \
echo "RAM_TEXT = 0x57e00000" >> $(obj)board/samsung/smdk6400/config.tmp;\
else \
echo "RAM_TEXT = 0xc7e00000" >> $(obj)board/samsung/smdk6400/config.tmp;\
fi
@$(MKCONFIG) smdk6400 arm arm1176 smdk6400 samsung s3c64xx
@echo "CONFIG_NAND_U_BOOT = y" >> $(obj)include/config.mk


#======================================================================

把其复制一遍，在把smdk6400改为smdk6410即可

6、在顶层目录下执行

make smdk6410_config

make

7、对具体硬件在从细节上分析，进行移植。