升级G1 Image

一直在用的G1是1.5的老版本，今天准备升级到相对新的官方Image。

 

1：很奇怪，从http://developer.htc.com/adp.html 没有办法再下载Image了，只能从同事这里找到以前下好的东东。我用的是signed-dream_devphone_userdebug-ota-150275.zip

2：同时按开机键和camera键，查看RADIO，HBOOT  版本，按通话键＋menu＋开机键盘重启

3：由于RADIO 版本已经是最新的了，我就只更新recover mode下的zip包好了

4： 按照以下步骤，除了最后一步好像没有看到什么 updating firmware log 以外，其余正常

 

1. Ensure that the SD card containing the updated radio image is inserted in the device
2. Boot the device normally
3. Connect the device to your development machine over USB.
4. At a command line, ensure that adb recognizes your device by issuing this command:

   $ adb devices
                                         

   You should see your device in the console output generated by the command

5. Use the adb sync command to copy the contents of the radio image package to the update.zip archive on the device's SD card:

   $ adb push <recovery-image-package>.zip /sdcard/update.zip
                                         

   The command prints the number of bytes copied and the elapsed time, then completes. However, note that the files are still being copied in the background, so wait a minute or two before continuing. If you continue too soon and terminate the operation before it is complete, you will get a "bad update.zip" error later, when you try to install the update.

   To ensure that the entire recovery image package is copied before you continue, use this command:

   $ adb shell sync
                                         

   When sync returns, all of the data has been copied to the device.

6. Reboot the device into recovery mode by holding down the HOME key during reboot. When the device enters recovery mode, it displays a "!" icon.
7. With the recovery console displayed, open the sliding keyboard and hold down the ALT+L key combination to enable log output in the recovery console.
8. Next, hold down the ALT+s key combination to install the update. An "installing update" icon and progress bar (or a similar status message) are displayed ??when the progress bar completes, the installation is finished.
9. Press the HOME-BACK key combination to write the recovery image, update the firmware, and automatically reboot. Note that if you do not use HOME-BACK at this point, the device will not load the updated radio image. After writing the image, the device shows a "updating firmware" icon for a few seconds and then automatically reboots in normal mode.

After the device reboots normally, the operation is complete.

 

 

5： 重启设备，查看FW 版本，已经是最新了。以前装的软件竟然 基本还能够用，呵呵。