keil4与ulink2调试LPC2368流水灯仿真

一年之前还用的ulink2那时还要手动装驱动，改文件，不想现在，都成了自动的。感叹下时代的进步！！

配置下keil4右击工程>>“options for target”>>"debug">>"use UNLIK ARM Debugger"返回工程，ctrl+F5，出现“error: could not load file xxx.axf debugger aborted”去官网查了下具体解决方法http://www.keil.com/support/docs/3411.htm，就是下载压缩包，解压放到C:\Keil\ARM\BIN下，替换原来的TLM.dll

这个问题解决了，下载还是失败，keil4右击工程>>“options for target”>>"debug">>"use UNLIK ARM Debugger">>"setting"改下通信频率100KHz问题解决

附下代码，也没心情写了，去pudn下了个

/*
============================================================
LPC23XX 学习板 GPIO功能演示
作者: Mingtree	[email protected]   http://www.mcu123.com
============================================================
*/


#include <LPC23xx.H>

void delay (unsigned int dly)
{
	unsigned int i;
	
	for ( ; dly>0; dly--)
		for (i=0; i<50000; i++);
}

int main (void) {
  unsigned int n;

  PINSEL10 = 0;		 //禁止ETM

  FIO2DIR=0x000000ff;
  FIO2MASK = 0x00000000;

  while (1) {                               /* Loop forever */
    for (n = 0x00000001; n <= 0x00000080; n <<= 1) {
      /* Blink LED 0, 1, 2, 3, 4, 5, 6, 7 */
      FIO2SET = n;                           /* Turn on LED */
      delay(30);                              /* Delay */
      FIO2CLR = 0x000000FF;                  /* Turn off LEDs */
    }
  }
}