华为交换机配置手工负载分担模式链路聚合LACP示例_第1张图片 

配置手工负载分担模式链路聚合LACP示例

[S-switch-A]interface Eth-Trunk1
[S-switch-A-Eth-Trunk1]quit
[S-switch-A]interface GigabitEthernet0/0/1
[S-switch-A-GigabitEthernet0/0/1] eth-trunk 1
[S-switch-A-GigabitEthernet0/0/1]interface GigabitEthernet0/0/2
[S-switch-A-GigabitEthernet0/0/2]eth-trunk 1
[S-switch-A-GigabitEthernet0/0/2]interface GigabitEthernet0/0/3
[S-switch-A-GigabitEthernet0/0/3]eth-trunk 1

[S-switch-B]interface Eth-Trunk1
[S-switch-B-Eth-Trunk1]quit
[S-switch-B]interface GigabitEthernet0/0/1
[S-switch-B-GigabitEthernet0/0/1] eth-trunk 1
[S-switch-B-GigabitEthernet0/0/1]interface GigabitEthernet0/0/2
[S-switch-B-GigabitEthernet0/0/2]eth-trunk 1
[S-switch-B-GigabitEthernet0/0/2]interface GigabitEthernet0/0/3
[S-switch-B-GigabitEthernet0/0/3]eth-trunk 1

查看Eth-Trunk 1的运行壮态
[S-switch-B]dis trunkmembership eth-trunk 1
Trunk ID: 1
Used status: VALID
TYPE: ethernet
Working Mode : Normal
Number Of Ports in Trunk = 3
Number Of Up Ports in Trunk = 3
Operate status: up
 
Interface GigabitEthernet0/0/1, valid, operate up, weight=1
Interface GigabitEthernet0/0/2, valid, operate up, weight=1
Interface GigabitEthernet0/0/3, valid, operate up, weight=1

后面就针对eth-trunk 1进行端口配置即可