配置redis服务器允许redis-cli 远程连接

远程连接redis服务器查询key 列表 报错。

keys *

(error) DENIED Redis is running in protected mode because protected mode is enabled, no bind address was specified, no authentication password is requested to clients. In this mode connections are only accepted from the loopback interface. If you want to connect from external computers to Redis you may adopt one of the following solutions: 1) Just disable protected mode sending the command 'CONFIG SET protected-mode no' from the loopback interface by connecting to Redis from the same host the server is running, however MAKE SURE Redis is not publicly accessible from internet if you do so. Use CONFIG REWRITE to make this change permanent. 2) Alternatively you can just disable the protected mode by editing the Redis configuration file, and setting the protected mode option to 'no', and then restarting the server. 3) If you started the server manually just for testing, restart it with the '--protected-mode no' option. 4) Setup a bind address or an authentication password. NOTE: You only need to do one of the above things in order for the server to start accepting connections from the outside.

 

原因是redis服务器有IP绑定和安全保护模式，解决方法

一、编辑redis.conf   (我的服务器在  /etc/redis.conf )

1、注释掉  bind 127.0.0.1

2、把保护模式关闭 protected-mode no

 

二、重启redis

重启redis 必须指定配置文件

redis-server  /etc/redis.conf

 

再次远程连接redis 可以正常查询设置 redis了