思科交换机命令大全(一)

switch>         用户模式
1 :进入特权模式  enable
switch> enable
switch#
 
2 :进入全局配置模式  configure terminal
switch> enable
switch c onfigure terminal
switch(conf)#
 
3 :交换机命名 hostname aptech2950     aptech2950为例
switch> enable
switch c onfigure terminal
switch(conf)#hostname aptch-2950
aptech2950(conf)#
 
4 :配置使能口令  enable password cisco    cisco为例
switch> enable
switch c onfigure terminal
switch(conf)#hostname aptch2950
aptech2950(conf)# enable password cisco
 
5 :配置使能密码  enable secret ciscolab    cicsolab为例
switch> enable
switch c onfigure terminal
switch(conf)#hostname aptch2950
aptech2950(conf)# enable secret ciscolab
 
6 :设置虚拟局域网vlan 1   interface vlan 1
switch> enable
switch c onfigure terminal
switch(conf)#hostname aptch2950
aptech2950(conf)# interface vlan 1
aptech2950(conf-if)#ip address 192.168.1.1 255.255.255.0      配置交换机端口ip和子网掩码
aptech2950(conf-if)#no shut                              是配置处于运行中
aptech2950(conf-if)#exit
aptech2950(conf)#ip default-gateway 192.168.254             设置网关地址
 
7 :进入交换机某一端口 interface fastehernet 0/17           17端口为例
switch> enable
switch c onfigure terminal
switch(conf)#hostname aptch2950
aptech2950(conf)# interface fastehernet 0/17
aptech2950(conf-if)#
 
8 :查看命令  show
switch> enable
switch# show version  察看系统中的所有版本信息
show interface vlan 1  查看交换机有关ip协议的配置信息
show running-configure 查看交换机当前起作用的配置信息
show interface fastethernet 0/1  察看交换机1接口具体配置和统计信息
show mac-address-table        查看mac地址表
show mac-address-table aging-time  查看mac地址表自动老化时间
 
9 :交换机恢复出厂默认恢复命令
switch> enable
switch# erase startup-configure
switch# reload
 
 
 
10 :双工模式设置
switch> enable
switch c onfigure terminal
switch2950(conf)#hostname aptch-2950
aptech2950(conf)# interface fastehernet 0/17                 17端口为例
aptech2950(conf-if)#duplex full/half/auto                    full , half, auto三个可选项
 

你可能感兴趣的:(职场,休闲)