WiFi Temperature Monitor-3080

Operation Manaul of WiFi Temperature Sensor

eMonitor

---

1. Standard Inclusion

1

2. WiFi Setup

Very few steps to finish Wi-Fi setup.

1

1. Use your smart device's Wi-Fi connection setup, connect to the monitor's network, which will show up as eMonitor_-- . No password required. (How to get SN will be illustrated later.)

2. Whilst connected to the monitor's network, open a web browser and navigate to http://11.11.11.1; Enter the username "admin" and password "admin".

3. Connect to home router by clicking "Find AP" or manually input home router's SSID (your home Wi-Fi networks' SSID) and Key (your home Wi-Fi networks' password) and then click "Save&Reboot"

4. After rebooted, the page will be shown as below.

   
   
   

   1

5. Find your monitor in your windows network, which will be shown up as eMomitor_xxxxxxxx (xxxxxxxx is unique SN of eMonitor).

Note: Note down the Meter SN for later registration on the plarform.

1

3. Monitor on DeviceBit

3.1 How it works

3

3.2 Sign up on DeviceBit

4

Step1, Visit the website https://www.lwkits.com, click "Log in", and the login page is shown

Step2, Click "Sign up", fill up the information on sign up page, enter the meter SN.

SN: Serial Number is unique ID of your Monitor, it is a combination of 8 digits or letters.

3.3 Add your monitor on DeviceBit

5

Login and click "Add A Device". SN and Name must be filled. Normal Value Range and Alarm Sending is optional to be filled.

3.4 View your data on webpage

After a while, you can view you data on DeviceBit.

6

3.5 View your data on Wechat

You can also view data on Wechat by following DeviceBit Wechat ID. Scan the below QRcode to follow:

7

Login via Wechat by following steps

8

View your data on Wechat

9

3.6 Alerts setting and Notification

? The following part will introduce how to set Notice Groups, and receive alarms

? 3.1 Add A New Contact

? Click on Notice Groups?-> Contacts?-> New Contact

image

??Enter the name, Email etc. of this contact and then click on Save. ?

image

Add more contacts in the same way.

image

Click on View Code to bind your WeChat ID.

image

Scan it with your WeChat

image

image

3.2 Add A New Group?

??Go to Notice Groups?-> New Group

image

Enter the group name, tick the contacts, email addresses, or WeChat ID as needed, and then save.

image

image

3.3 Alert Settings

Go to List, and click on Edit.

image

Set the normal temperature range for your device and select the notice group, e.g. the Temperature group which is just set.

image

Then, click on OK and the settings are successfully saved.