3-6 Aruba交换机实用配置-登录管理 2020

实例拓扑如下：

登陆帐号密码配置

Access-2# configure
Access-2(config)# password operator //用户模式密码
New password for operator: hpe
Re-enter the new password for operator: hpe

you are allowed to move to enable mode because you have not set a manager password.
Set a manager password now. The password is “hpe” (case-sensitive).
Access-2# config
Access-2(config)# password manager //enable密码
New password for manager: hpe
Re-enter the
new password for manager: hpe

验证：
Log in as the operator.
<-output omitted->
Username: operator
Password: hpe
Try to move to enable mode.
Access-2> enable
As you see, you are prompted for credentials because manager access is restricted by a
password. Enter manager for the username and password.
Username: manager
Password: hpe
From enable mode, you now have complete access to the switch CLI

Enable SSH

Access-2 (console session)

1. Return to the terminal session with Access-2. Move to global configuration mode.
2. Create a key for SSH.
   Access-2(config)# crypto key generate ssh rsa bits 2048
   Installing a new key pair. If the key/entropy cache is
   depleted, this could take up to a minute.
   The installation of a new key pair is successfully completed.
3. SSH is enabled by default when the switch has an SSH key. However, if your switch did not have
   a key, SSH would have been disabled on it. Enter this command to make sure that SSH is
   enabled:
   Access-2(config)# ip ssh

创建新用户名密码

Change the manager credentials to the ones shown in the table. Remember that passwords are
case-sensitive! (You will see ** rather than the password letters.)
Access-2(config)# password manager user-name admin
New password for manager: hpe
Please retype new password for manager: hpe