交换机A和交换机B之间通过3条GE以太网连接，活动链路为2，配置如下：

  • SwitchA配置
 system-view
[HUAWEI] sysname SwitchA

[SwitchA] interface eth-trunk 1 # 创建Eth-Trunk1
[SwitchA-Eth-Trunk1] mode lacp # 配置LACP模式
[SwitchA-Eth-Trunk1] trunkport gigabtiethernet 0/0/1 to 0/0/3 # 添加接口成员
[SwitchA-Eth-Trunk1] max active-linknumber 2 # 设置活动上限阀值
[SwitchA-Eth-Trunk1] quit

[SwitchA] lacp priority 100 # 配置系统优先级使其成为主控端
[SwitchA] interface gigabitethernet 0/0/1
[SwitchA-GigabitEthernet0/0/1] lacp priority 100 # 配置活动链路优先级
[SwitchA-GigabitEthernet0/0/1] quit
[SwitchA] interface gigabitethernet 0/0/2
[SwitchA-GigabitEthernet0/0/2] lacp priority 100 # 配置活动链路优先级
[SwitchA-GigabitEthernet0/0/2] quit
  • SwitchB配置
 system-view
[HUAWEI] sysname SwitchB

[SwitchB] interface eth-trunk 1 # 创建Eth-Trunk1
[SwitchB-Eth-Trunk1] mode lacp # 配置LACP模式
[SwitchB-Eth-Trunk1] trunkport gigabtiethernet 0/0/1 to 0/0/3 # 添加接口成员
[SwitchB-Eth-Trunk1] max active-linknumber 2 # 设置活动上限阀值
[SwitchB-Eth-Trunk1] quit

[SwitchB] interface gigabitethernet 0/0/1
[SwitchB-GigabitEthernet0/0/1] lacp priority 100 # 配置活动链路优先级
[SwitchB-GigabitEthernet0/0/1] quit
[SwitchB] interface gigabitethernet 0/0/2
[SwitchB-GigabitEthernet0/0/2] lacp priority 100 # 配置活动链路优先级
[SwitchB-GigabitEthernet0/0/2] quit

说明： LACP优先级值越大，优先级越低，系统LACP优先级为32768