Raspberry PI2 and both i2c busses 打开RaspberryPi2的第二个i2c口 (i2c-0)

开启第一个：http://www.raspberrypi-spy.co.uk/2014/11/enabling-the-i2c-interface-on-the-raspberry-pi/

第二个：

I’m working on a project that uses devices that have overlapping i2c addresses. In more recent raspberry pi instances they changed how this works and there is quite a bit of confusion on forums about how to do this. Here’s your 2015 update for using NOOBS as a starting point:

Add these two lines to /boot/config.txt:

echo dtparam=i2c_arm=on >> /boot/config.txt
echo dtparam=i2c_vc=on >> /boot/config.txt

append bcm2708.vc_i2c_override=1 to /boot/cmdline.txt

WIth this, you can use both i2c, pins 3,5 and 27,28. Keep in mind you may need a pull-up for pins 27,28 and your i2c setup, where 3,5 have them on-board.

root@raspberrypi:/home/pi# i2cdetect -l
i2c-0    i2c           3f205000.i2c                        I2C adapter
i2c-1    i2c           3f804000.i2c                        I2C adapter

root@raspberrypi:/home/pi# ls -ld /dev/i2c*
crw-rw—T 1 root i2c 89, 0 May 27 01:08 /dev/i2c-0
crw-rw—T 1 root i2c 89, 1 May 27 01:08 /dev/i2c-1

重启就可以看到了