window eNSP安装使用教程

1，需要的安装包：

链接：https://pan.baidu.com/s/1U38OENqOeKXDN0-ipFTxwA?pwd=sd12 
提取码：sd12

安装eNSP

根据提示：需要先安装wireshark, VirtualBox, winPcap,所以我们接下来先依次安装上面三个安装包。

1，安装wireshark

 

 不用改配置，一直下一步就可以。

更改安装路径：

2，安装winpcap

解决方法：

找到下面相应的文件，并把扩展名修改即可：

C:\Windows\SysWOW64 的wpcap.dll改成 wpcap.dll.old
C:\Windows\SysWOW64的packet.dll改成 packet.dll.old

改了之后再安装可以成功。

3，安装VirtualBix

 

 更改安装路径

 

 4，安装eNsp

 

 安装成功后测试：

 点击AR1->右击->启动,后右击->CLI进入华为命令行。

system-view进入命令行配置

######################################################

Apr 12 2023 10:07:24-08:00 Huawei %%01IFPDT/4/IF_STATE(l)[0]:Interface Ethernet 
0/0/0 has turned into UP state.
sys    
system-view 
[Huawei]interface Ethernet 0/0/0   
[Huawei-Ethernet 0/0/0]ip address 10.10.10.1 24

AR2相同的配置 

system-view 
[Huawei]interface Ethernet 0/0/1   
[Huawei-Ethernet /0/1]ip address 10.10.10.3 24

配置完成后，在AR2/AR1上ping包查看通道。

 [Huawei]ping 10.10.10.1
  PING 10.10.10.1: 56  data bytes, press CTRL_C to break
    Reply from 10.10.10.1: bytes=56 Sequence=1 ttl=255 time=110 ms
    Reply from 10.10.10.1: bytes=56 Sequence=2 ttl=255 time=30 ms
    Reply from 10.10.10.1: bytes=56 Sequence=3 ttl=255 time=20 ms
    Reply from 10.10.10.1: bytes=56 Sequence=4 ttl=255 time=40 ms
    Reply from 10.10.10.1: bytes=56 Sequence=5 ttl=255 time=10 ms

  --- 10.10.10.1 ping statistics ---
    5 packet(s) transmitted
    5 packet(s) received
    0.00% packet loss
    round-trip min/avg/max = 10/42/110 ms

[Huawei]display interface Ethernet 0/0/0
Ethernet0/0/0 current state : UP
Line protocol current state : UP
Description:HUAWEI, AR Series, Ethernet0/0/0 Interface
Switch Port, PVID :    1, TPID : 8100(Hex), The Maximum Frame Length is 1628
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 00e0-fca7-470a
Last physical up time   : 2023-04-12 11:11:24 UTC-08:00
Last physical down time : 2023-04-12 11:11:09 UTC-08:00
Current system time: 2023-04-12 11:12:42-08:00
Port Mode: COMMON COPPER
Speed :  100,  Loopback: NONE
Duplex: FULL,  Negotiation: ENABLE
Mdi   : AUTO
Last 300 seconds input rate 128 bits/sec, 0 packets/sec
Last 300 seconds output rate 8 bits/sec, 0 packets/sec
Input peak rate 584 bits/sec,Record time: 2023-04-12 11:11:40
Output peak rate 280 bits/sec,Record time: 2023-04-12 11:11:40

Input:  42 packets, 5166 bytes
  Unicast:                  0,  Multicast:                  42
  Broadcast:                0,  Jumbo:                       0
  Discard:                  0,  Total Error:                 0

  CRC:                      0,  Giants:                      0
  Jabbers:                  0,  Throttles:                   0
  Runts:                    0,  Symbols:                     0
  Ignoreds:                 0,  Frames:                      0

Output:  3 packets, 357 bytes
  Unicast:                  0,  Multicast:                   3
  Broadcast:                0,  Jumbo:                       0
  Discard:                  0,  Total Error:                 0

  Collisions:               0,  ExcessiveCollisions:         0
  Late Collisions:          0,  Deferreds:                   0

    Input bandwidth utilization threshold : 100.00%
    Output bandwidth utilization threshold: 100.00%
    Input bandwidth utilization  :    0%
    Output bandwidth utilization :    0%

[Huawei]lldp  enable 
Apr 12 2023 11:16:52-08:00 Huawei LLDP/4/ADDCHGTRAP:OID: 16777216.50331648.10066
3296.16777216.67108864.16777216.3674669056.83886080.419430400.2248146944.3355443
2.83886080 Local management address is changed. (LocManIPAddr=1.0.0.127)
[Huawei]
Info: Global LLDP is enabled successfully.
[Huawei]
Apr 12 2023 11:16:52-08:00 Huawei LLDP/4/ENABLETRAP:OID: 16777216.50331648.10066
3296.16777216.67108864.16777216.3674669056.83886080.419430400.2248146944.3355443
2.16777216 Global LLDP is enabled.


[Huawei]display  lldp neighbor brief 
Local Intf   Neighbor Dev             Neighbor Intf             Exptime
Eth0/0/0     Huawei                   Eth0/0/1                  99