华为AR28-31路由器的E1捆绑配置

华为AR28-31路由器的E1捆绑配置

查看当前的配置 display current-configuration 进入到系统配置状态（相当于CISCO设备的EN 命令） sys System View: return to User View with Ctrl+Z. [huawei] [quidway]sysname huawei [huawei] 保存配置 [huawei]sxdye The configuration will be written to the device. Are you sure?[Y/N]y Please input the file name(*.cfg)[flash:/config.cfg]:config0821.cfg Now sxdying current configuration to the device. Sxdying configuration flash:/config0821.cfg. Please wait... ...... Current configuration has been sxdyed to the device successfully. 再次保存，就直接保存到之前起的文件名中。 sxdye The configuration will be written to the device. Are you sure?[Y/N]y Now sxdying current configuration to the device. Sxdying configuration flash:/config0821.cfg. Please wait... ....... Current configuration has been sxdyed to the device successfully. 配置以太网网口 [huawei]interface Ethernet 0/0 [huawei-Ethernet0/0]ip addre [huawei-Ethernet0/0]ip address 172.16.5.249 255.255.255.0 [huawei-Ethernet0/0]quit [huawei] （如用ctrl+z 就退回到 状态下了。） 配置虚拟终端 [huawei]user-interface vty 0 4 [huawei-ui-vty0-4]authentication-mode password huawei-ui-vty0-4]set authentication password cipher huawei2 （设置密码为huawei2)#p# 配置4E1串口模块（4线路捆绑） # controller E1 2/0 using e1 # controller E1 2/1 using e1 # controller E1 2/2 using e1 # controller E1 2/3 using e1 # # interface Serial2/0:0 link-protocol ppp ppp mp Mp-group 0 # interface Serial2/1:0 link-protocol ppp ppp mp Mp-group 0 # interface Serial2/2:0 link-protocol ppp ppp mp Mp-group 0 # interface Serial2/3:0 link-protocol ppp ppp mp Mp-group 0 # interface Mp-group0 ip address 10.10.10.170 255.255.255.252 # 配置静态路由 ip route-static 0.0.0.0 0.0.0.0 10.0.10.169 preference 60 华为AR28-31路由器的SNMP配置 在之前使用mrtg进行采集的过程中，会报错： 。。。。m4only...等等。。是因为snmp-agent sys-info version v3 ，而我们改为了all就可以了。 见下面的第四行。 snmp-agent snmp-agent local-engineid 000007DB7F00000100002E25 snmp-agent community read public snmp-agent sys-info version all snmp-agent target-host trap address udp-domain 10.10.10.9 udp-port 5000 params securityname public