WINCE开发中eboot模式下TFTP方式下载NK镜像时的问题

EBOOT模式下，无法下载NK镜像，可以连接到PC机，PC机也可以检测到目标，就是在下载的时候卡住，显示的速度为0KB/S，串口打印信息如下：
0) IP address: 192.168.1.6
1) Subnet mask: 255.255.255.0
2) DHCP: Disabled
3) Boot delay: 3 seconds
4) Reset to factory default configuration
5) Startup image: LAUNCH EXISTING
6) Program disk image into SmartMedia card: Enabled
7) Program CS8900 MAC address (10:23:45:67:89:AB)
8) Kernel Debugger: ENABLED
9) Format Boot Media for BinFS
B) Mark Bad Block at Reserved Block 
D) Download image now(USE TFTP)
E) Erase Reserved Block 
F) Low-level format the Smart Media card
L) LAUNCH existing Boot Media image
R) Read Configuration 
U) Download image now(USE USB)
W) Write Configuration Right Now

Enter your selection: d
CS8900: MAC Address: 10:23:45:67:89:ab
INFO: Probe: CS8900 is detected.
INFO: Init: CS8900_Init OK.
System ready!
Preparing for download...
INFO: *** Device Name 'TQ244035243' ***
+EbootSendBootmeAndWaitForTftp
Sent BOOTME to 255.255.255.255
Sent BOOTME to 255.255.255.255
Sent BOOTME to 255.255.255.255
Sent BOOTME to 255.255.255.255
Sent BOOTME to 255.255.255.255
Sent BOOTME to 255.255.255.255
Packet has the following data:
  boot.bin[NULL]octet[NULL]
TFTP packet could have 1 name/value pairs
Locked Down Link 1
Src IP 192.168.1.6 Port 03D4 Dest IP 192.168.1.14 Port DD09
Default TFTP block size set to: 512 bytes
There were no options detected in the TFTP
EthDown::TFTPD_OPEN::boot.bin
-EbootSendBootmeAndWaitForTftp
USB host is not connected yet.

就在这里卡住了，最诡异的是最后一句居然是USB host is not connected yet.，也仔细查看过代码，发现就是不能执行OEMPreDownload( )这个函数，一直没有查出问题，代码没道理不执行这个函数的，怎么会跳到USB host is not connected yet.这里呢？

 

 

问题解决方法：

我使用的是天嵌TQ2440的wince6.0的BSP包，它的EBOOT有个BUG，就是使用TFTP下载时会受到USB的影响，就是因为USB下载功能影响的。屏蔽usb下载功能的方法：修改Eboot源码中的sources文件的 $(_TARGETPLATROOT)\lib\$(_CPUINDPATH)\oal_blcommon.lib \
为：
  $(_PLATCOMMONLIB)\$(_CPUINDPATH)\oal_blcommon.lib \
就行了。