imieye:Attention to install the camera

Surveillance camera installation method:
1. Under the condition of meet the requirements of monitoring target field, its installation height: indoor ground should not be below
2.5 m, should not be less than 3.5 m from the ground outside.
2. Surveillance cameras and supporting device, such as lens, shield, stents, wiper and so on, the installation should be strong, the operation should be
Flexible, should pay attention to prevent damage, and in harmony with the surrounding environment.
3. Under the environment of strong electromagnetic interference, the installation of surveillance cameras should be isolated from ground insulation.
4. The signal lines and power supply cord shall be introduced respectively, exposed part of the hose protection, does not affect the rotation of yuntai.
5. Surveillance cameras should be installed in the car door at the top of the left or the right, and can effectively monitor the elevator cars within the crew
Facial features.
Yuntai, decoder installation:
1. Yuntai installation shall be firm and rotates without shaking.
2. According to technical conditions and system design requirements, product inspection yuntai rotation Angle range whether meet the requirements.
3. The decoder shall be installed near the yuntai or ceiling (but must leave manhole).
Surveillance camera control equipment installation:
1. The consoles, racks (frame) installation position should comply with the design requirements, installation should be smooth solid, easy to operation and maintenance.
Cabinet frame) on the back, lateral clear distance from the wall should be accordance with the requirements of the maintenance.
2. Surveillance cameras all control, display, record and other terminal equipment installation should be smooth, easy operation. The monitor
Device (screen) should avoid external light point-blank, when inevitable, measures should be taken to avoid light. In the console, cabinet (frame)
Equipment should be installed in the ventilation cooling measures, internal connectors to connect to the device should be firm.
3. The control room all cables should be according to equipment installation location set cable slot hole and into the line, arrange, strapping, Ed
, and have permanent marks.
Maintenance of the monitoring system, matters needing attention before use
1. The host before the electricity, you must first check, avoid burn out due to poor contact parts. Check the method is:
A. shaking the host to check internally whether there is loose phenomenon;
B. Check whether the card is from behind the host have skewed and poor contact of the phenomenon;
C. voltage selection switch is set at 230, and matching with the power supply voltage; You have not normal phenomenon, please do not electricity. Immediately notify the supplier, to listen to your processing.
2. The panel after many interface is the pin type, connection before check whether the pin is skewed, avoid damage interface.
3. Interface matching is bad, such as audio and video connectors match tighter, please replace the connector.
4. The host for card structure, external connection may not be hard push and hard to pull, avoid to cause poor contact.
5. The host work, fixed position, please, don't drag.
6. The host interface attribute, the related peripherals connected completely, and check the contacts are in good condition.
7. According to correct procedure to turn it off, shall not be shut down, shut the power way avoid system damage.
The maintenance of the hard disk video recorder
Computer systems if maintain undeserved, even in normal use, also may fail.
About the hard disk video host maintenance, users, please note the following:
1. Assign a host operation, timing system and data backup and maintenance, the fault may cause the loss falls
To a minimum.
2. According to normal procedure to turn it off, do not use electricity way to turn it off.
3. The long-term continuous operation when the host, it is recommended that a week off for a few minutes, and then restart the run.
4. Suggest to host equipped with uninterruptible power supply (UPS) on-line equipment, avoid lose power or system damage caused by voltage instability.
5. The hard disk video host for monitoring is special, not as a normal computer use[url][/url]

www.imieye.com