scaling mnesia with local_content

原文地址： http://dukesoferl.blogspot.com/2008/08/scaling-mnesia-with-localcontent.html
so we've been spending the last two weeks trying to scale our mnesia application for a whole bunch of new traffic that's about to show up. previously we had to run alot of ec2 instances since we were using ets (RAM-based) storage; once we solved that we started to wonder how many machines we could turn off.

initial indications were disappointing in terms of capacity. none of cpu, network, memory, or disk i/o seemed particularly taxed. for instance, even though raw sequential performance on an ec2 instance can hit 100mb/s, we were unable to hit above 1mb/s of disk utilization. one clue: we did get about 6mb/s of disk utilization when we started a node from scratch. in that case, 100 parallel mnesia_loader processes grab table copies from remote nodes. thus even under an unfavorable access pattern (writing 100 different tables at once), the machines were capable of more.

one problem we suspected was the registered process mnesia_tm, since all table updates go through this process. the mnesia docs do say that it is "primarily intended to be a memory-resident database". so one thought was that mnesia_tm was hanging out waiting for disk i/o to finish and this was introducing latency and lowering throughput; with ets tables, updates are cpu bound so this design would not be so problematic. (we already have tcerl using the async_thread_pool, but that just means the emulator can do something else, not the mnesia_tm process in particular). thus, we added an option to tcerl to not wait for the return value of the linked-in driver before returning from an operation (and therefore not to check for errors). that didn't have much impact on i/o utilization.

we'd long ago purged transactions from the serving path, but we use sync_dirty alot. we thought maybe mnesia_tm was hanging out waiting for acknowledgements from remote mnesia_tm processes and this was introducing latency and lowering throughput. so we tried async_dirty. well that helped, except that under load the message queue length for the mnesia_tm process began to grow and eventually we would have run out of memory.

then we discovered local_content, which causes a table to have the same definition everywhere, but different content. as a side effect, replication is short-circuited. so with very minor code changes we tested this out and saw a significant performance improvement. of course, we couldn't do this to every table we have; only for data for which we were ok with losing if the node went down. however it's neat because now there are several types of data that can be managed within mnesia, in order of expense:
transactional data. distributed transactions are extremely expensive, but sometimes necessary.
highly available data. when dirty operations are ok, but multiple copies of the data have to be kept, because the data should persist across node failures.
useful data. dirty operations are ok, and it's ok to lose some of the data if a node fails.
the erlang efficiency guide says "For non-persistent database storage, prefer Ets tables over Mnesia local_content tables.", i.e., bypass mnesia for fastest results. so we might do that, but right now it's convenient to have these tables acting like all our other tables.

interestingly, i/o utilization didn't go up that much even though overall capacity improved alot. we're writing about 1.5 mb/s now to local disks. instead we appear cpu bound now; we don't know why yet.