Step 8:委托在线控制
此时，委托在线控制器被执行。您将使用DMCplus Manage启动和运行控制器，以图形化方式监视控制器并进行必要的修改。详情请参阅DMCplus Manage and View详细文档。
注：DMCplus 3.0及以上版本提供了一个基于Web的浏览器。请与管理员联系确认基于Web的浏览器是否可用。
DMCplus在线控制程序首次运行时，将以“预测模式”运行一两天以验证程序是正确运行的，并检查模型的准确性。在这种模式下，控制器将执行所有的控制计算，但计算出的动作将不写入过程。
在此期间，将进行操作人员的非正规培训。我们将提供简要操作员导览，其指定了DMCplus控制器目的、其确认的变量、操作员使用的显示界面，以及控制器打开与关闭的过程。
附原文：
Step 8: Commission the online controller
At this point,online controller commissioning is performed. You will use DMCplus Manage to start and maintain the controller,and View to monitor the controller graphically and make any necessary changes.Refer to the DMCplus Manage and View documentation for details.
Note: DMCplus version 3.0 and later provides a Web-based viewer. Check with your administrator to see if the Web-based viewer is available.
The DMCplus online control program is first run in"prediction mode" for a day or two to verify proper program functioning,and check the accuracy of the model. In this mode, the controller performs all control calculations, but the moves are not sent to the process.
During this time, informal operator training takes place. A brief operator guide is provided, specifying the objective of the DMCplus controller, the variables that it considers, the operator displays to be used,and the procedure for turning the controller on and off.
2015.9.15