[ECE] P2.2 Draw the output waveform

Draw the output waveform for a two input OR gate with the input waveform as shown below. 

According to the given Question

given logic gate is OR gate

OR gate: if any input are high output logic will high

A	B	Y=A+B
0	0	0
0	1	1
1	0	1
1	1	1

Then 

Here's a simple example using a text-based representation:

1. Input Waveforms:

   • Assume you have two input waveforms, let's call them A and B.

2. Aligning with Dashed Lines (虚线对齐):

   • Place dashed lines vertically to align the rising and falling edges of the input waveforms. This helps in visually associating input transitions with corresponding output changes.

3. Segmentation:

   • Divide the time axis into segments corresponding to different input configurations (combinations of A and B values).
   • For example, one segment could represent when both A and B are low (0), another segment when A is low and B is high (1), and so on.

4. Determining Y's Value in Segments:

   • Within each segment, determine the output Y value based on the OR gate logic.
   • If either A or B (or both) is high (1), Y will be high (1).

5. Waveform Drawing:

   • Draw the output waveform (Y) based on the determined values for each segment.
   • Use solid lines to represent the actual output waveform.
   • Here's a simple example using a text-based representation:

   •        Input Waveforms:   A: 0───1───0───1───0
                               B: 1───0───1───1───0
     
            Time Axis:         1   2   3   4   5
     
            Segmentation:      |---|---|---|---|
     
            Y's Value:         1   1   1   1   0
     
            Output Waveform:   1───1───1───1───0
     

   •