接口方式下帧中继配置实验

我是个新手在学用cisco路由模拟器，上chinaitlab做了做flash实验，发现用到帧中继，就用gns3做了下，总是不通，上网查了查，讲大的多讲小的少，怕忘了传上博客，绝非原创，但我又不知选什么，请不要见笑

 

R1(config)#int s0/0
R1(config-if)#shut
R1(config-if)#ip add 192.168.1.129 255.255.255.240
R1(config-if)#frame-relay interface-dlci 102
！注意这里ip地址是对端的IP地址dlci则是本地的dlci
R1(config-if)#frame-relay map ip 192.168.1.130 102
R1(config-if)#no shu

R2的配置
en
Router#config t
Router(config)#hostname R2
R2(config)#int s0/0
R2(config-if)#shut
R2(config-if)#ip add 192.168.1.130 255.255.255.240
R2(config-if)#frame-relay interface-dlci 201
！注意这里ip地址是对端的IP地址dlci则是本地的dlci
R2(config-if)#frame-relay map ip 192.168.1.129 201
R2(config-if)#no shu

!检查

!ping 对方端口通
R1#ping 192.168.1.130

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.1.130, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 16/45/108 ms
！ping 本地端口 不通找不到原因请指点
R1#ping 192.168.1.129

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.1.129, timeout is 2 seconds:
.....
Success rate is 0 percent (0/5)