BIP2087E: Broker BrokerDemo was unable to process the internal configuration mes

今天部署的时候,.出现下面这个错误,

BIP4041E：执行组'默认'发现一个无效的配置信息。

BIP2210E：无效的配置信息：属性名称'allowQueryWSDL'不为目标对象的有效'Main.TestMessageFlows。'

 
Begin running task [Deploying [BrokerDemo.bar] to execution group [default]]

BIP2087E: Broker BrokerDemo was unable to process the internal configuration message.

The entire internal configuration message failed to be processed successfully.

Use the messages following this message to determine the reasons for the failure. If the problem cannot be resolved after reviewing these messages, contact your IBM Support center. Enabling service trace may help determine the cause of the failure.

BIP4041E: Execution group 'default' received an invalid configuration message. See the following messages for details of the error.

The broker was asked to deploy a message flow which contained properties that were not recognized by the broker. This typically results from a message flow requiring a version or type of node that is not supported by the broker installation.

Check that the message flow is only using properties or nodes that are supported on the broker. Check that all necessary user-defined extensions are installed and that they are of a version that is compatible with the message flow.

BIP2210E: Invalid configuration message: attribute name 'allowQueryWSDL' not valid for target object 'Main.OperationReadinessServiceToHCDM.'.

The message broker received a configuration message containing the attribute name 'allowQueryWSDL' which is not valid for the target object 'Main.OperationReadinessServiceToHCDM.'.  This can be caused by a mismatch in levels between the Message Broker Toolkit and the broker, or as a result of a user or third party written user-defined node where the implementation library installed at the broker does not match the node definition held at the Message Broker Toolkit.

Ensure that the levels of code installed at the Message Broker Toolkit and broker are consistent.  If they are, identify the supplier of the target object and report the problem to them.  If this is IBM, contact your IBM support center.

The task was unsuccessful: The deployment was unsuccessful. Check error messages above for explanation.

 

解决方案：

 

1.找到主流程,检查一下整个的流程.时候有编译错误.

 

2.找到SOAP Input节点右击->选择Properties->HTTP Transport中的 ->Enable Sopor For ?wsdl.去掉复选框中的选项.即可。