【转载】QuartusII软件异常：Error: Top-level design entity " " is undefined

使用Quartus进行数字电路设计时，遇到了下面的编译错误：

Info: *******************************************************************
Info: Running Quartus II 64-Bit Analysis & Synthesis
 Info: Version 11.0 Build 157 04/27/2011 SJ Full Version
 Info: Processing started: Thu May 15 13:09:59 2014
Info: Command: quartus_map --read_settings_files=on --write_settings_files=off simulate -c simulate
Info: Parallel compilation is enabled and will use 2 of the 2 processors detected
Info: Found 1 design units, including 1 entities, in source file simulate.v
 Info: Found entity 1: modelsim_test
Error: Top-level design entity "simulate" is undefined

Error: Quartus II 64-Bit Analysis & Synthesis was unsuccessful. 1 error, 0 warnings
 Error: Peak virtual memory: 324 megabytes
 Error: Processing ended: Thu May 15 13:10:01 2014
 Error: Elapsed time: 00:00:02
 Error: Total CPU time (on all processors): 00:00:01
Error: Quartus II Full Compilation was unsuccessful. 3 errors, 0 warnings

 

原因是

verilog文件（.v）里的模块名和顶层实体名(Top-level design entity，一般就是.v文件的文件名)不一致。

1. module modelsim_test(clk,rst_n,div);

2. input clk;

3. input rst_n;

4. output div;

5. reg div;

6. always@(posedge clk or negedge rst_n)

7. if(!rst_n)div<=1'b0;

8. else div<=~div;

9. endmodule

上面的模块名是modelsim_test，而工程目录下的verilog文件名是simulate，如下图。

解决方法是：将modelsim_test修改为simulate。

编译成功！