Distcc+pump安装配置手册（方法2）

Distcc+pump安装配置手册（方法2）

服务器端(计算机名为：zhimingubtpc.local)：

$ sudo useradd distcc
$ sudo apt-get install python-dev

$ sudo tar zxfv distcc-3.2rc1.tar.gz

$ cd distcc―3.2rc1

$ sh ./autogen.sh

$ ./configure �Cprefix=/usr/local/distcc

$ make

$ sudo make install

$ sudo mkdir /usr/local/distcc/log

$ sudo touch/usr/local/distcc/log/distcc.log

$ sudo chown �CR distcc:adm/usr/local/distcc/log

$ echo "aliasdistccd='/usr/local/distcc/bin/distccd --daemon --allow 10.0.1.0/24--log-file=/usr/local/distcc/log/distcc.log'" >> ~/.bashrc

$ source ~/.bashrc

开启distcc：

$ sudo distccd

关闭distcc：

$ sudo killall distccd

客户端：

$ sudo useradd distcc
$ $ sudo apt-get install python-dev

$ sudo tar zxfv distcc-3.2rc1.tar.gz

$ cd distcc―3.2rc1

$ sh ./autogen.sh

$ ./configure �Cprefix=/usr/local/distcc

$ make

$ sudo make install

$ sudo ln �Cs /usr/local/distcc/bin/distcc/usr/local/distcc/bin/cc

$ sudo ln �Cs /usr/local/distcc/bin/distcc/usr/local/distcc/bin/gcc

$ sudo ln �Cs /usr/local/distcc/bin/distcc/usr/local/distcc/bin/g++

$ sudo mkdir /usr/local/distcc/log

$ sudo touch/usr/local/distcc/log/distcc.log

$ sudo chown �CR distcc:adm/usr/local/distcc/log

$ echo "aliasdistccd='/usr/local/distcc/bin/distccd --daemon --allow 10.0.1.0/24--log-file=/usr/local/distcc/log/distcc.log'" >> ~/.bashrc

$ source ~/.bashrc

开启distcc：

$ sudo distccd

关闭distcc：

$ sudo killall distccd

$ vi ~/.bashrc (在最后添加)
按a或i进入编辑模式

exportDISTCC_HOSTS='localhost,cpp,lzo zhimingubtpc.local,cpp,lzo'

export PATH=/usr/local/distcc/bin:/usr/bin:/bin
按Esc键退出编辑模式
:wq (保存并退出)

$ source ~/.bashrc

在make前添加pump即可

查看下gcc路径：

$ which gcc  (如果显示/usr/lib/distcc/gcc则是说明环境变量生效了)

本文出自 “linux” 博客，谢绝转载！