CCNA实验之--三层交换
好长时间没写了，最近在预习NP的书，顺便回顾一下NA的实验吧。
Switch1基本配置：
Switch>en
Switch#conf t
Switch(config)#hostname Switch1
Switch1(config)#vlan 10
Switch1(config-vlan)#name vlan_10
Switch1(config)#int fa0/1
Switch1(config-if)#switchport access vlan 20
Switch1(config-if)#switchport mode trunk
Switch1(config-if)#end
Switch2基本配置：
Switch>en
Switch#conf t
Switch(config)#hostname Switch2
Switch2(config)#vlan 20
Switch2(config-vlan)#name vlan_20
Switch2(config-vlan)#int fa0/1
Switch2(config-if)#switchport access vlan 20
Switch2(config-if)#switchport mode trunk
Switch2(config-if)#end
三层交换机上的配置：
Switch>en
Switch#conf t
Switch(config)#hostname Switch0
Switch0(config)#vlan 10
Switch0(config-vlan)#name vlan_10
//注意，这里一定要创建vlan 10和vlan 20
Switch0(config-vlan)#vlan 20
Switch0(config-vlan)#name vlan _20
Switch0(config-vlan)#int vlan 10 //作为PC1的网关
Switch0(config-if)#ip address 192.168.10.254 255.255.255.0
Switch0(config-if)#int vlan 20 //作为PC2的网关
Switch0(config-if)#ip address 192.168.20.254 255.255.255.0
Switch0(config-if)#int fa0/1
Switch0(config-if)#switchport mode trunk
Switch0(config-if)#int fa0/2
Switch0(config-if)#switchport mode trunk
Switch0(config-if)#end
在三台交换机上验证配置，
Switch1#sh vlan brief
VLAN Name Status Ports
---- -------------------------------- --------- -------------------------------
1 default active Fa0/3, Fa0/4, Fa0/5, Fa0/6
Fa0/7, Fa0/8, Fa0/9, Fa0/10
Fa0/11, Fa0/12, Fa0/13, Fa0/14
Fa0/15, Fa0/16, Fa0/17, Fa0/18
Fa0/19, Fa0/20, Fa0/21, Fa0/22
Fa0/23, Fa0/24, Gig1/1, Gig1/2
10 vlan_10 active Fa0/2
20 VLAN0020 active
1002 fddi-default active
1003 token-ring-default active
1004 fddinet-default active
1005 trnet-default active
Switch2#sh vlan brief
VLAN Name Status Ports
---- -------------------------------- --------- -------------------------------
1 default active Fa0/3, Fa0/4, Fa0/5, Fa0/6
Fa0/7, Fa0/8, Fa0/9, Fa0/10
Fa0/11, Fa0/12, Fa0/13, Fa0/14
Fa0/15, Fa0/16, Fa0/17, Fa0/18
Fa0/19, Fa0/20, Fa0/21, Fa0/22
Fa0/23, Fa0/24, Gig1/1, Gig1/2
20 vlan_20 active Fa0/2
1002 fddi-default active
1003 token-ring-default active
1004 fddinet-default active
1005 trnet-default active
Switch0#sh vlan brief
VLAN Name Status Ports
---- -------------------------------- --------- -------------------------------
1 default active Fa0/3, Fa0/4, Fa0/5, Fa0/6
Fa0/7, Fa0/8, Fa0/9, Fa0/10
Fa0/11, Fa0/12, Fa0/13, Fa0/14
Fa0/15, Fa0/16, Fa0/17, Fa0/18
Fa0/19, Fa0/20, Fa0/21, Fa0/22
Fa0/23, Fa0/24, Gig0/1, Gig0/2
10 vlan_10 active
20 vlan_20 active
1002 fddi-default active
1003 token-ring-default active
1004 fddinet-default active
1005 trnet-default active
Switch0#sh int trunk
Port Mode Encapsulation Status Native vlan
Fa0/1 on 802.1q trunking 1
Fa0/2 on 802.1q trunking 1
Port Vlans allowed on trunk
Fa0/1 1-1005
Fa0/2 1-1005
Port Vlans allowed and active in management domain
Fa0/1 1,10,20,1002,1003,1004,1005
Fa0/2 1,10,20,1002,1003,1004,1005
Port Vlans in spanning tree forwarding state and not pruned
Fa0/1 1,10,20,1002,1003,1004,1005
Fa0/2 1,10,20,1002,1003,1004,1005
Switch0#sh ip route
【cut out】
Gateway of last resort is not set
C 192.168.10.0/24 is directly connected, Vlan10
C 192.168.20.0/24 is directly connected, Vlan20
验证连通性，
PC1可以与PC2通信，实验成功。